Setting the speaker impedance and language

Caution

If you are to use 6-ohm speakers, set “SPEAKER IMP.” to “6ΩMIN” as follows BEFORE using this unit.

Before using this unit, set the speaker impedance of the connected speakers and the language of the menu items and messages.

1Make sure this unit is turned off.

2Press and hold MPROGRAM on the front panel and then press BMASTER ON/OFF inward to the ON

position to turn on this unit.

Press and hold MPROGRAM until “ADVANCED SETUP” appears in the front panel display.

PROGRAM While holding down

MASTER

PUSH ENTER

Connections

7Press BMASTER ON/OFF to release it outward to the OFF position to save the new setting and turn off this unit.

The setting you made is reflected next time you turn on this unit.

Turning this unit on and off■Turning on this unit

Press BMASTER ON/OFF on the front panel inward to the ON position to turn on this unit.

When you turn on this unit by pressing BMASTER ON/OFF, the main zone is turned on.

Note

After this unit is turned on, it takes approximately 20 seconds until this unit produces sounds, and while “Please wait” appears in the front panel display, this unit does not accepts the front panel operations and stores the remote control operations. This unit performs the stored remote control operations after “Please wait” disappears.

■Turning off this unit

Preparation

A D V A N C E D S E T U P

3Rotate MPROGRAM to select “SPEAKER IMP.”.

4Press MPROGRAM repeatedly to select “8ΩMIN” or “6ΩMIN”.

5Rotate MPROGRAM to select “LANGUAGE”.

6Press MPROGRAM repeatedly to select the desired language setting.

Choices: ENGLISH (English), JAPANESE (Japanese), FRENCH (French), GERMAN (German), SPANISH (Spanish), RUSSIAN (Russian)

Notes

•You can also select the language setting by using GUI menu. See page 114 for details.

•Some languages are not displayed in the front panel display or Zone OSD.

LANGUAGE

GUI menu

Front panel

Zone OSD

display

 

 

 

RUSSIAN

 

 

—

JAPANESE

 

—

—

Other languages

 

 

 

··· The selected language is displayed.

—··· The selected language is not displayed. The menu items and messages are displayed in English.

Press BMASTER ON/OFF on the front panel again to release it outward to the OFF position to turn off this unit.

Notes

•AMAIN ZONE ON/OFF on the front panel as well as EPOWER and DSTANDBY on the remote control are operational only when BMASTER ON/OFF is pressed inward to the ON position.

•Basically, we recommend that you use the standby mode to turn off this unit.

■Set the main zone to the standby mode

Press AMAIN ZONE ON/OFF (or DSTANDBY) to set

the main zone to the standby mode.

In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.

■Turning on the main zone from the standby mode

Press AMAIN ZONE ON/OFF (or EPOWER) to turn on

the main zone.

y

•When you turn on this unit, there will be a delay for a few seconds before this unit can reproduce sound.

•These buttons are operational only when BMASTER ON/OFF is pressed inward to the ON position.

If there are some problems...

•First, turn off and then turn on this unit again.

•If problems persist, initialize the parameters of this unit. See page 154 for details.

43 En