Use this menu to adjust the network and USB system parameters.
■Configuration (Network configuration)Use this feature to view the network parameters (IP address, etc.) or to change them manually.
DHCP (DHCP setting)
Use this feature to select whether this unit can obtain the network parameters (IP address, subnet mask, default gateway, primary DNS server and secondary DNS server) from the DHCP server of the connected network.
Choice | Descriptions |
|
|
Select this setting when this unit can obtain the network | |
| parameters from the DHCP server of the connected |
| network. |
|
|
Select this setting when you set the network parameters | |
| manually. |
|
|
IP Address (IP address)
Use this parameter to specify an IP address assigned to this unit. This value must not duplicate the one used for other devices in the target network.
Subnet Mask (Subnet mask)
Use this parameter to specify the subnet mask value assigned to this unit.
y
For most of the cases, the subnet mask value can be set as “255.255.255.0”.
Default Gateway (Default gateway)
Use this parameter to specify the IP address of the default gateway.
DNS Server (P) (Primary DNS server)
DNS Server (S) (Secondary DNS server)
Use this parameter to specify the IP address of the primary and secondary DNS (Domain Name System) servers.
Note
If you have only one DNS address, enter the DNS address in “DNS Server (P)”. If you have two or more DNS addresses, enter one of them in “DNS Server (P)” and another in “DNS Server (S)”.
Setup (Setup)
Select “Setup” to confirm the settings of the “Configuration” parameters.
Procedure of the network configuration
1From the top GUI menu, press 9k / n on the remote control repeatedly and then 9h to select “Configuration”.
2Press 9k / n repeatedly and then 9h to select “DHCP”.
Graphical user interface (GUI) menu
3Press 9k / n to select “On” or “Off” and then 9ENTER to confirm.
•If you select “On”, you do not have to set other network parameters. Refer to step 5 and finish the configuration.
•If you select “Off”, you need to set other network parameters. Refer to steps 4 through 6 to set the parameters.
Note
When “DHCP” is set to “On”, you cannot select and adjust any other network settings. To specify the other parameters, you need to first set “DHCP” to “Off”.
4Press 9k / n to select the desired parameter and then 9h.
5Press 9l / h repeatedly to select the digit to change and then press 9k / n repeatedly to change the number.
6Press 9ENTER to confirm the setting of the parameter.
7Repeat steps 4 through 6 to configure each network parameter.
8Press 9n repeatedly to select “Setup” and then 9ENTER to finish configuration.
Note
In case you have changed your network configuration, you may need to reconfigure the network settings again.
y
You can reset the network settings of this unit to the initial factory settings by using “NETWORK” of “INITIALIZE” in the advanced setup menu (see page 144).
Operation | Advanced |
|
|