Mode Performance

Part (Settings for each Part)

You can edit each Part in a Performance. Use Knob [A] to select the Part, then set its parameters. The following six screens are available, though their contents will vary according to the Part selected.

•Part Mixer

•Part Tone

•Part Layer

•Part Receive switch

•Part Controller

•Part Insertion Effect

Part Mixer

You can set various Voice output parameters for each Part. The following two screens are available.

MIX Vce (Mix Voice)

MIX Level

MIX Vce (Mix Voice)

You can assign a Voice to each Part. Use Knob [A] to select the Part, then set its Voice parameters.

The display will vary as follows according to the Part selected.

• If Part01 to Part16 has been selected

You can use the same method as the Category Search (Page 62) to set the Voice.

MIX’Vce) Memory Number Ctgry Search￿

Part01 PRE1:128(H16)[Pf:GrandPiano]

• If PartPL (Plug-in) has been selected

Set the Voice for the Plug-in Part. This screen is only displayed if a Plug-in Board has been installed. Use Knob [B] to select PLG INT (internal memory) and the MSB/LSB (Plug-in Board’s Bank), and use Knob [C] to select the Program Number.

MIX’Vce) Bank Number Ctgry Search￿ PartPL NORM/001:128(H16)[Pf:GrandPiano]

■Bank

❏Settings:

PartPL (Plug-in): PLG INT (Plug-in Internal), MSB/LSB (Plug-in Bank)

For details about Plug-in Banks (Bank Select MSB/LSB), refer to the Owner’s Manual that came with your Plug-in Board.

■Number (Program Number)

❏Settings:

PLG INT (Plug-in Internal): 1 ~ 64

MSB/LSB (Plug-in Bank): 1 ~ 128

There may be a delay when changing programs for a Plug- in Part (since voice data and default settings need to be sent). To change Voices for a Plug-in Part in a song, you should insert the Program Changes in the less data- intensive areas of the song. When selecting a Plug-in Board Voice, you should use the Program Number of the Parameter Change (multi-part). Details are given in the Owner’s Manual that comes with the Plug-in Board.

In Performance Mode, the Part assignment for a Plug-in Board is fixed at “15” for PLG.

For details about Plug-in Voices, refer to the Owner’s Manual that came with your Plug-in Board.

■Memory (Voice Memory)

❏Settings:

PRE1 (Preset 1), PRE2 (Preset 2), INT (Internal Normal), EXT (External Normal), PRE (Preset Drum), INT (Internal Drum), EXT (External Drum)

■Number (Program Number)

❏Settings:

1 ~ 128 (for Normal Voices), DR1 ~ DR8 (for Preset Drum), DR1 ~ DR2 (for Internal/External Drum)

Details about Categories are given in the Category List on Page 65.

• If Part17 to Part32 has been selected

You can set Voices for Parts 17 to 32 if you have a multitimbral Plug-in board installed. Use Knob [B] to select the Voice Bank and Knob [C] to select the Program Number.

 

 

 

 

 

MIX’Vce)

Bank Number

￿

 

Part17 NORM/001:001(A01)[Pf:GrandPno]

 

 

 

 

 

■Bank/Number (Bank/Program Number)

❏Settings: Refer to the Owner’s Manual that came with the Plug-in board.

This setting is only held temporarily and cannot be stored with the Performance.

114