Drum Key Pitch

Set the pitch of each Drum Key. The tunings and Pitch EG parameters can be set for each Drum Key.

PCH Tune (Pitch Tune)

 

 

 

 

 

 

 

PCH’Tune)

Coarse

Fine

VelSens

￿

 

Key=C 3

+ 0

+ 0

+63

 

 

 

 

 

 

 

■Coarse

Adjust the pitch of each Drum Key Wave (or Normal Voice) in semitones.

❏ Settings: -48 ~ +48

For a Normal Voice, this parameter adjusts the position of its note (not its pitch) relative to note C3. For example, let’s assume the original Voice consists of a two-Element piano-like sound up to note C3 and a two- Element string-like sound from note C#3 upwards. Adjusting this Coarse setting by +1 would not change the pitch of the piano-like sound to C#3. Instead, note C#3 of the original Voice (i.e., the string-like sound) would be used.

■Fine

Fine-tune the pitch of each Drum Key Wave (or Normal Voice).

❏Settings: -64 ~ +63

■VelSens (Velocity Sensitivity)

Set the velocity sensitivity of the pitch. Positive settings will cause the pitch to rise the harder you play the keyboard and negative settings will cause it to fall.

❏Settings: -64 ~ 0 ~ +63

This parameter is only available if the Type parameter in the OSC Wave screen is set to “wave.”

Drum Key Filter

You can apply filter settings to the Drum Voice.

A Low Pass Filter and High Pass Filter can be applied per Wave to change its tonal characteristics.

This parameter is only available if the Type parameter in the OSC Wave screen is set to “wave.”

FLT Cutoff (Filter Cutoff)

 

 

 

 

 

 

 

 

FLT’Cutoff) LPF

VelSens

Reso

HPF

￿

 

Key=C 3

255

+63

31

0

 

 

 

 

 

 

 

 

■LPF (Low Pass Filter)

Set the Cutoff frequency of the Low Pass Filter. Only frequencies below this point are passed.

You can then use the Reso (Resonance) parameter to add further character to the sound.

❏ Settings: 0 ~ 255

Details about the Low Pass Filter are given on Page 78.

■VelSens (Velocity Sensitivity)

Set the velocity sensitivity of the Low Pass Filter Cutoff frequency. Positive settings will cause the cutoff frequency to rise the harder you play the keyboard and negative settings will cause it to fall.

❏Settings: -64 ~ 0 ~ +63

■Reso (Resonance)

Set the amount of Resonance (harmonic emphasis) applied to the signal at the Cutoff frequency.

This can be used in combination with the Cutoff frequency of the Low Pass Filter to add further character to the sound.

❏Settings: 0 ~ 31

Details about Resonance are given on Page 80.

■HPF (High Pass Filter)

Set the Cutoff frequency of the High Pass Filter. Only frequencies above this point are passed.

❏ Settings: 0 ~ 255

Details about the High Pass Filter are given on Page 79.

Drum Key Amplitude

You can set amplitude (output level) parameters for each Drum Key. The following two parameters are available.

This parameter is only available if the Type parameter in the OSC Wave screen is set to “wave.”

AMP AEG (Amplitude Envelope Generator) AMP VelSens (Amplitude Velocity Sensitivity)

Voice Mode

91