Mode Utility

Synchronize the tempo settings of the S30

and the Plug-in Board.

If you are using a Plug-in Board capable of generating arpeggio patterns, you can synchronize its tempo with that of the S30.

1Enter Utility Mode and select the PLG MIDI screen. Then use the appropriate knob to set the Clock parameter to “on.”

2Enter Voice Mode, select the Plug-in Voice of the respective Plug-in Memory, then enter Voice Edit Mode.

3Use knob [A] to select “Elem,” as shown at the bottom left of the screen.

4Use the [PAGE] knob to select the name of the Plug-in Board, as shown at the bottom left of the screen. Then enter the Plug-in native part parameter screen.

5Use the [PAGE] knob to select the Plug-in native part parameter for the tempo. Then use the appropriate knob to select MIDI (midi).

Now, the tempo of the Plug-in Board is synchronized with the MIDI clock signal received from the S30.

To synchronize with an external MIDI clock source, enter Utility Mode and set the Sync parameter of the MIDI Other screen to “MIDI.”

Utility Job Mode

In Utility Job Mode, you can restore your synthesizer’s factory default settings (Factory Set). There is only one screen in this Mode.

Factory Set (Restore Factory Defaults)

You can restore the synthesizer’s default Internal Voices and Performances, as well as its System and other settings.

Once you edit any settings, their factory defaults will be overwritten and lost.

You can restore the factory default settings as follows.

When you restore the factory default settings, all the current settings for the all the Internal Voices and Performances will be overwritten with the factory defaults. Make sure you are not overwriting any important data. You should back up any important data to Memory Card, or to some external device beforehand.

1Press the [JOB] key in Utility Mode. You will see the Factory Set screen.

MODE

VOICE PERFORM STORE

UTILITY CARD SEQ

PLAY

EDIT

JOB

PLAY/

STOP

 

 

COMPARE

 

 

UTIL Factory Set)￿

Job

2When you press the [ENTER] key, you will see a confirmation message.

3Press the [INC/YES] key to execute the Factory Set job. You will see the “Completed.” message displayed after the job has completed. You can cancel a job while it is being executed by pressing the [DEC/NO] key.

4Press the [EXIT] key to return to Utility Mode.

134