QED Filter (Quick Edit Filter)

These parameters control filters which affect the tonal quality of the Voice. If you are using LPF (Low Pass Filter) and HPF (High Pass Filter) combined together, the parameters in the QED Filter page only affects LPF.

 

 

 

 

 

 

QED’Filter)

Cutoff

Reso

￿

 

C 1234

+63

+63

 

 

 

 

 

 

■Cutoff

Set the cutoff frequency. The frequency set here will be a center frequency for signals to be filtered when they pass through each filter.

❏Settings: -64 ~ 0~ +63

■Reso (Resonance)

Set the amount of Resonance (harmonic boost) applied to the signal around the Cutoff frequency. This is a useful way of adding further character to the sound.

❏Settings: -64 ~ 0~ +63

QED EG (Quick Edit Envelope Generator)

These four parameters control the change in the output level of a Voice over the time that a note is played.

 

 

 

 

 

 

 

 

QED’EG)

Attack

Decay

Sustain

Release

￿

 

C 1234

+63

+63

+63

+63

 

 

 

 

 

 

 

 

 

Level

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Sustain

 

 

 

 

 

 

 

Level

 

 

 

 

 

 

 

 

 

Time

 

 

 

 

 

 

 

 

 

 

Attack

Decay

Release

 

 

 

Time

Time

Time

 

 

 

 

 

 

 

 

 

 

Key

 

 

on

 

 

Key off

 

 

 

■Attack

Set the transition time from the moment a key on the keyboard is pressed to the point at which the level of the Voice reaches its peak.

❏Settings: -64 ~ 0~ +63

■Decay

Set the transition time from the point at which the level of the Voice reaches its peak to the point at which it levels off.

❏Settings: -64 ~ 0 ~ +63

■Sustain

Set the level of the Voice maintained while the note on the keyboard is being held down.

❏Settings: -64 ~ 0 ~ +63

■Release

Set the transition time from the point at which the note on the keyboard is released to the point at which the level of the Voice reaches zero.

❏Settings: -64 ~ 0~ +63

Common Arpeggio

The following four parameters control the behavior of the Arpeggiator.

ARP Type (Arpeggio Type)

ARP Limit (Arpeggio Note Limit)

ARP Mode (Arpeggio Mode)

ARP PlayEF (Arpeggio Play Effect)

ARP Type (Arpeggio Type)

These are the basic parameters of the Arpeggiator.

 

 

 

 

 

 

 

ARP’Type) Type

Tempo

Switch

Hold

￿

 

C 1234 UpOct1:Sq

120

on

on

 

 

 

 

 

 

 

■Type

Set the Arpeggio Type.

❏Settings: (see the separate Data List)

Sq (Sequence):

Creates a general arpeggio phrase. Mainly octave up/down phrases.

Ph (Phrase):

Creates more musical phrases than Sq. Starting with “Techno,” there are phrases for a wide variety of musical genres, and for creating backing tracks for guitar, piano and other instruments.

Dr (Drum Pattern):

Creates drum pattern-type phrases. Phrase genres covered include rock and dance. This Type is ideal for use with drum and percussion sounds.

Ct (Control):

Creates tonal changes. No note information is created. The Key Mode parameter in Arpeggio Mode must be set to “direct.”

■Tempo

Set the Arpeggio Tempo.

❏Settings: 25 ~ 300

[MIDI] is displayed here and the parameter cannot be altered if MIDI sync is enabled (Page 131).

Voice Mode

67