FRONT BRAKE AND REAR BRAKE CHAS

4.Install:

Pin 1

Washer 2

• Cotter pin 3 New

NOTE:

After installing, check the brake pedal height. Refer to “REAR BRAKE ADJUSTMENT” sec- tion in the CHAPTER 3.

Front brake hose

1.Install:

• Brake hose 1

T.

R.

10 Nm (1.0 m · kg, 7.2 ft · lb)

To brake hose holder 2.

NOTE:

Before tightening the bolt (brake hose holder), align the top a of the brake hose neck with the brake hose holder bottom b. Then pass the brake hose in front of the axle boss c and fit it into the hose groove d so that the brake hose does not contact the nut (wheel axle).

2.Install:

Brake hose cover 1

Washer 2

Bolt [brake hose cover (M8)] 3

T.

R.

16 Nm (1.6 m · kg, 11 ft · lb)

Bolt [brake hose cover (M6)] 4

T.

R.

7 Nm (0.7 m · kg, 5.1 ft · lb)

3.Pass the brake hose through the front brake hose guide 1, then through the guide a on the protector 2.

5 - 23

Page 250
Image 250
Yamaha WR250FM service manual Front brake hose