Yamaha WR250FM service manual Hot starter lever holder Bolt hot starter lever holder

HANDLEBAR CHAS

Zero mm (Zero in)

Zero mm (Zero in)

8. Install:

• Start switch 1

• Brake master cylinder 2

• Brake master cylinder bracket 3

• Bolt (brake master cylinder bracket) 4

T9 Nm (0.9 m · kg, 6.5 ft · lb) . R.

• Clamp 5

NOTE:

•The start switch and brake master cylinder bracket should be installed according to the dimensions shown.

•Install the bracket so that the arrow mark a faces upward.

•First tighten the bolt on the upper side of the brake master cylinder bracket, and then

tighten the bolt on the lower side.

9.Install:

• Light switch 1

T.

R.

2 Nm (0.2 m · kg, 1.4 ft · lb)

10.Install:

•Engine stop switch 1

•Clutch lever holder 2

•Bolt (clutch lever holder) 3

T.

R.

4 Nm (0.4 m · kg, 2.9 ft · lb)

•Hot starter lever holder 4

•Bolt (hot starter lever holder) 5

T.

R.

4 Nm (0.4 m · kg, 2.9 ft · lb)

•Clamp 6

NOTE:

•The engine stop switch, clutch lever holder and clamp should be installed according to the dimensions shown.

•Pass the engine stop switch lead in the mid- dle of the clutch lever holder.

5 - 44