Yamaha WR250FM service manual Rear Brake Adjustment, Front Brake PAD Inspection and Replacement

REAR BRAKE ADJUSTMENT/ FRONT BRAKE PAD INSPECTION AND REPLACEMENT

INSP

ADJ

ÈÉ

EC364002

REAR BRAKE ADJUSTMENT

1.Check:

•Brake pedal height a

Out of specification → Adjust.

Brake pedal height a: 5 mm (0.20 in)

2.Adjust:

• Brake pedal height

Pedal height adjustment steps:

•Loosen the locknut 1.

•Turn the adjusting nut 2 until the pedal height a is within specified height.

•Tighten the locknut.

WARNING

•Adjust the pedal height between the maximum È and the minimum É as shown. (In this adjustment, the bolt 3 end b should protrude out of the threaded portion 4 but not be less than 2 mm (0.08 in) c away from the brake pedal 5).

•After the pedal height adjustment, make sure that the rear brake does not drag.

FRONT BRAKE PAD INSPECTION AND REPLACEMENT

1.Inspect:

•Brake pad thickness a

Out of specification → Replace as a set.

Brake pad thickness:

4.4mm (0.17 in) <Limit>: 1.0 mm (0.04 in)

2.Replace:

• Brake pad

Brake pad replacement steps:

•Remove the pad pin plug 1.

3 - 27