Reference [Rhythm]

range is 000 - 722. For a list of numbers and corresponding sound names, refer to the appendix at the end of this manual (→ p. 181).

• PITCH

Adjusts the pitch of the drum/percussion sound for the pad. The setting range is -7.9 - 0 (reference pitch) - 7.9, in steps of 0.1 (1/10 of a semitone).

• LEVEL

Adjusts the output level for the pad. The setting range is 1 - 15.

• PAN (Panning)

Adjusts the left/right stereo position (panning) for the pad. The maximum setting range is L63 (far left) - 0 (center) - R63 (far right). The actual range will vary, depending on the type of instrument selected.

• GROUP (Pad group)

Selects the group to which the pad belongs (0 - 7) and the type of sound produced when pads are hit in succession (PL/ MN). The setting range is PL0 - PL7 and MN0 - MN7. When PL is selected, hitting two pads in succession will produce overlapping sound, i.e. the previous sound continues while the next one starts. When MN is selected, the previous sound stops when the next one starts.

GROUP=PLGROUP=MN

The numbers 0 - 7 specify the group to which the pad belongs (0 = no group, 1 - 7: respective group). Pads in the same group cannot produce sound at the same time.

For example, if you assign an open hi-hat sound and closed hi-hat sound to two pads in the same group, the open hi-hat sound will cease when you play the closed hi-hat sound, resulting in realistic action.

HINT

Pad group numbers are common for PL and MN. For exam- ple, pads assigned to PL1 and to MN1 belong to the same group.

• REV SEND (Reverb send)

Sets the reverb send level for the pad. The setting range is 0

-127. The setting does not depend on the reverb send level in the track parameter.

5. Press the pad for which you want to make asetting, and turn the dial to select a setting value.

When you press a pad, the current setting for that pad appears on the display. In this condition, you can use the dial to change the value.

HINT

If you press the [DRUM MIXER] key in this condition, you can use the faders on the panel to select the pad and change the LEVEL setting at the same time. (The label under each fader shows which pad is controlled by it.)

Controlled pad

When you operate a fader that controls another pad than the currently assigned one, that pad becomes the new editing target, and the LEVEL setting changes.

Dr MixerPad=1-1 15

Dr Mixer

Pad=1-2 76. Repeat steps 3 - 5 as necessary to edit other pads.

ZOOM MRS-1266

112