Reference [Mixer]

Adjusting the depth of the send/re- turn effects

The depth of the send/return effects can be adjusted by setting the volume (send level) of the signal that is sent from the input mixer to each send/return effect (chorus/delay, reverb). In normal operation, sending the signal from the input mixer to the send/return effect will only apply the effect to the signal that is sent from the OUTPUT jacks, and will not affect the signal that is recorded on a track.

HINT

To record the signal processed by the send/return effect on

a track, you can use bounce recording while the respective input [ON/OFF] key is on (→ p. 45).

1. Press the [CHORUS/DELAY] key or [REVERB] keyto select a patch for the send/return effect.

The display changes and shows the currently selected patch

of the selected effect (chorus/delay or reverb).

2. Turn the dial to select the patch you want to use.

When you have selected the patch, press the [EXIT] key.

3. Press the [CHORUS/DELAY SEND] key or the

[REVERB SEND] key in the track parameter section

to select send/return effect.

Press the [CHORUS/DELAY SEND] key if you want to adjust the chorus/delay send level or the [REVERB SEND] key if you want to adjust the reverb send level.

For example, when the [CHORUS/DELAY SEND] key is pressed, a screen such as shown below appears.

TR1

CHO SEND 0

Parameter

Setting value

4. Press the desired [ON/OFF] key in the input

section.

The input mixer (INPUT) is selected as target for setting the send level.

INPUT

CHO SEND 0

5. Turn the dial to select the effect depth.

Higher values result in more effect depth (stronger effect).

The range and default values for the parameters are shown

below.

●CHORUS/DELAY SEND: 0 - 100 (default: 0)●REVERB SEND: 0 - 100 (default: 0)

HINT

•When the chorus/delay parameter is shown on the display, pressing the [CHORUS/DELAY SEND] key will cause the signal sent from the input mixer to chorus/delay to be switched on/off. (The key will be out when this is off.)

•In the same way, when the reverb parameter is displayed, pressing the [REVERB SEND] key will cause the signal sent from the input mixer to reverb to be switched on/off.

6. When you have finished making settings, press the

[EXIT] key.

The unit returns to the main screen.

Adjusting the pan/balance

This section explains how to adjust the pan (stereo position) of the signal sent from the input mixer to the MASTER OUTPUT jacks and the recording tracks, or the balance (the volume balance between two channels).

1. Press the [PAN] key in the track parameter section.

The screen for adjusting the PAN parameter appears.

TR1

PAN 0

2. Press an [ON/OFF] key in the input section.

The input mixer will be selected for panning value

adjustment.

INPUT

PAN 0

ZOOM MRS-1266

78