Reference [Track Editing]

Editing V-takes

Recorded audio data can also be edited in V-take units. You can for example copy a certain V-take to another V-take for backup, or delete a V-take that is no longer needed.

Basic V-take editing steps

When editing audio data in V-take units, some steps are similar for each action. These are as follows.

1. From the main screen, press the [V-TAKE] key in

the track parameter section.

The key lights up, and a screen for switching the V-take appears on the display.

TR 1- 1

While this screen is shown, the level meter’s flashing/lit/out status indicates the V-take selection and the presence or absence of audio data.

V-take 1

 

 

Lit: recorded V-take

 

 

2

 

 

 

3

 

 

 

 

 

 

4

 

 

Flashing: currently selected V-take

5

 

 

 

 

6

7

8 Out: unrecorded V-take

9

10

Track

2. Use the cursor left/right keys and the dial to select

a track and V-take.

The status key for the currently selected track is lit in orange. You can also press a status key to select a track.

It is also possible to select the master track. In this case, the indication shows “M- 1” and the [MASTER] status key is lit.

ZOOM MRS-1266

3. Press the [UTILITY/TRACK EDIT] key in the display

section.

A menu for editing audio data in track units appears on the

display.

ERASE

TR 1- 1

4. Repeatedly press the [UTILITY/TRACK EDIT] keyto call up the desired command.

The following editing commands are available.

• ERASE

Erase the audio data on a specified track/V-take.

• COPY

Copy the audio data of a specified track/V-take to another track/V-take.

• MOVE

Move the audio data of a specified track/V-take to another track/V-take.

• EXCHG (Exchange)

Exchange the audio data of a specified track/V-take with the data of another track/V-take.

HINT

If necessary, you can also change your selection of track and

V-take from this screen.

5. Press the [ENTER] key.

The subsequent steps will differ, depending on which

command was selected. See the sections for the respective

commands.

6. When the editing command has been executed,press the [EXIT] key to return to the main screen.

61