Reference [Projects]

SIZE 000478MB

4. Press the [ENTER] key.

The indication “ALL SAVE SURE?” appears on the display.

ALL SAVE

SURE?

5. To execute the backup, press the [ENTER] key. To

cancel, press the [EXIT] key instead.

When you press the [ENTER] key, backup starts from the project with the lowest number. The display shows the disc number, the project number, and the indication “BURNING”. When the backup is finished, the display indication changes to “SAVE COMPLETE”.

Disc number

DISC001

BURNING 4

Project currently being saved

If the backup size is larger than the capacity of one CD-R/ RW disc, the disc will be ejected after it has been filled up, and a message prompting the user to insert the next CD-R/ RW disc appears.

CHANGE

DISK002 5

Projects already saved

The number at bottom right indicates up to which project is saved on this disc.

6. When the above message appears, insert a new

CD-R/RW disc, and press the [ENTER] key.

The backup operation resumes. If more than two discs are required, the above steps will be repeated. When the backup is finished, the display indication changes to “ALL SAVE COMPLETE”.

HINT

When the disc has been ejected, it also possible to abort the backup operation. To do this, press the [EXIT] key while the indication “CHANGE DISCxxx” (where xxx is the disc num- ber) is shown. The indication will change to “ALL SAVE CAN- CEL?”. Press the [ENTER] key to terminate the process.

NOTE

When a full backup spans several discs, restoring a single project requires you to first insert the discs on which it is saved. Be sure to note the disc number and the projects saved on the disc on the case and label of the disc.

7. To return to the main screen, press the [EXIT] key

several times.

Loading a project from CD-R/RW disc

To restore a project saved on CD-R/RW disc to the hard disk

of the MRS-1266, proceed as follows.

1. From the main screen, press the [BACK UP] key in the control section.

The backup menu appears.

BACKUP

SAVE

2. Use the cursor left/right keys to bring up the indication “BACKUP LOAD” on the display, and press the [ENTER] key.

The indication “LOAD InsDisc1” appears on the display.

LOAD

InsDisc1

3. Insert the CD-R or CD-RW disc where the project is saved into the CD-R/RW drive.

●If project was backed up as single project

Insert disc number 1.

ZOOM MRS-1266

144