Reference [Projects]

●If project was backed up as part of a full backup of all projects

Insert the disc where the project is stored. (If there are multiple discs, insert the first disc that contains data of the desired project.)

NOTE

•Also when you have backed up all projects in a single operation, restore is performed for individual projects.

•If the backup of the project spans multiple discs, be sure to insert the first disc that contains data of the desired project first. If you insert another disc, the project data will not be read correctly.

4. Press the [ENTER] key.

The name of the project on the disc, and the number which

is to be assigned to the project are shown on the display.

LOAD

 

 

 

 

 

 

 

 

PRJ012

 

7

Project

 

name

Project

 

number to

 

 

 

 

 

 

be assigned

HINT

When being restored to the MRS-1266, an empty project number is automatically assigned to the project. Even if a project with the same name already exists on the hard disk, it will not be overwritten.

5. To check the name of the directory from which the

project will be read, press the cursor down button.

The display shows the directory name.

DirName

PROJ012 7

Directory name

Press the cursor up key to restore the original display.

6. Turn the dial to select the project to load, and press

the [ENTER] key.

The indication “LOAD SURE?” appears on the display.

7. To execute the load operation, press the [ENTER]key. To cancel, press the [EXIT] key instead.

When you press the [ENTER] key, the project data are read

ZOOM MRS-1266

from the disc and loaded to the hard disk. When the operation is finished, the display indication changes to “LOAD COMPLETE”.

LOAD

wait...

If the backup spans multiple discs, the disc will be automatically ejected the data have been loaded, and a message prompting the user to insert the next CD-R/RW disc appears.

CHANGE

DISC002

8. When the above message appears, insert the next

CD-R/RW disc, and press the [ENTER] key.

The load operation resumes. If more than two discs are required, the above steps will be repeated. When the load operation is finished, the display indication changes to “LOAD COMPLETE”.

HINT

When the disc has been ejected, it also possible to abort the load operation. To do this, press the [EXIT] key while the indication “CHANGE DISCxxx” (where xxx is the disc number) is shown. The indication will change to “LOAD CANCEL?”. Press the [ENTER] key to terminate the process.

NOTE

If the backup of the project spans multiple discs, be sure to insert the discs in the correct order. Otherwise the project data will not be read correctly.

9. To return to the main screen, press the [EXIT] key

several times.

145