Zoom MRS-1266 END, TR 1, START, Copy Src, Copy Src, Copy Dst, main screen, [ENTER] key, copy range end point, 3. Press the [ENTER] key, 5. Press the [ENTER] key

Reference [Track Editing]

The subsequent steps will differ, depending on which

command was selected. See the sections for the respective

commands.

7. When the editing command has been executed,repeatedly press the [EXIT] key to return to themain screen.

NOTE

After performing an edit function and rewriting the audio data on a track, the original data cannot be restored. If you want to retain the condition before editing, use the capture function for that track (→ p. 63).

Copying a speciﬁed range of data

You can copy the audio data of a speciﬁed range to a speciﬁed position on a speciﬁed track. This action will overwrite the existing data at the destination location. The copy source data will be unchanged.

Copy source track

Copy

Copy destination track

1. Refer to steps 1 - 6 of “Basic editing steps” to

select the copy source track/V-take, and press the

[ENTER] key.

The display changes as follows. This screen lets you specify

the copy range start point.

Copy Src
START	00.

0 0 0 0 001-1

ZOOM MRS-1266

HINT

The edit range start point is shown on the left-hand counter in hours, minutes, seconds, milliseconds and on the right- hand counter in measures and beats.

2. Use the cursor left/right keys to move the ﬂashing section of the counter, and turn the dial to specify the copy start point.

The point can be speciﬁed in hours/minutes/seconds. When a value is speciﬁed, the measure/beat counter reﬂects the new location.

If you move the ﬂashing section to the MARKER ﬁeld on the display, you can specify a mark by turning the dial. In this case, the mark position becomes the editing start point. When you specify the point where there is no recorded data, an "*" symbol will appear on the display.

3. Press the [ENTER] key.

The display changes to “Copy Src END”. This screen lets you specify the copy range end point.

Copy Src
Copy Src
END	00

0 213 0	058-	3

4. Use the same procedure as in step 2 to specify thecopy range end point.

If you press the PLAY [R] key at this point, the speciﬁed range will be played.

5. Press the [ENTER] key.

The display now shows “Copy Dst TR xx-yy” (where xx is the track number and yy the V-take number). This screen lets you specify the copy destination track/V-take.

Copy Dst

TR 1- 1

NOTE

•If you have selected a single track as copy source, only a single track can be selected as copy destination.

•If you have selected two adjacent tracks or the master track

as copy source, only two adjacent tracks or the master track can be selected as copy destination. In this case, the currently selected V-take for each track becomes the editing target.