Phaser 3100MFP/X
2 Push the lower panel down until it clicks. | Print cartridge installation |
1 Stand in front of the machine.
2 Grasp the left and right sides of the cover and pull it towards you at the same time.
3Setup the back side tray stop by pushing the "PUSH" level (A).
Then adjust the side paper guides to the paper size by pushing lever (B) located on the left side guide. Adjust the length paper guide to the paper size by pushing lever (C).
4Take a paper stack, pull the paper off and align it on a flat surface.
5Put the paper stack in the tray (200 sheets of 80 g/ m² paper for instance).
6Slide the tray back in its location.
3Unpack the new print cartridge. Gently roll the cartridge 5 or 6 times to distribute the toner evenly inside the cartridge. Thoroughly rolling the cartridge will assure the maximum copies per cartridge.
Hold it by its handle.
4Insert the cartridge in its slot by pushing it until it clicks, then gently push the handle down (as shown below).
5Close the cover.
- 20 -