Xerox 3100MFP/X manual Setting up a machine, An example of how an AD-HOC network, May be set up

Page 55

Phaser 3100MFP/X

2827 - SETUP / WLAN / PARAMETERS / SECURITY

This parameter allows you to make your network secure by setting the encryption method to use in your WLAN network.

1

Press

, select the menu SETUP using the keys

 

or

and confirm with OK.

 

 

2

Select WLAN using the keys or

and confirm

 

with OK.

 

 

3

Select PARAMETERS using the keys

or and

 

confirm with OK.

 

 

4

Select SECURITY using the keys

or

and

 

confirm with OK.

 

 

5Choose WEP, WPA or OFF and confirm with OK.

-If you choose WEP, enter a password:

-In a 64 bit security configuration, the password must contain five characters exactly.

-In a 128 bit security configuration, the password must contain 13 characters exactly.

You may also enter the password using the hexadecimal system, if this is the case:

-For a 64 bit security configuration,

Note the password must contain exactly 10 hexadecimal characters.

-For a 128 bit security configuration, the password must contain exactly 26 hexadecimal characters.

-If you choose WPA, enter a WPA or WPA2 password (min. 8 characters to 63 characters max.).

The password can contain alphanumerical characters - numbers and letters - and any other symbol available on the keypad. The only invalid character is "€" (euro currency sign).

6Exit this menu by pressing the key.

2828 - SETUP / WLAN / PARAMETERS /

HOSTNAME

The machine name allows you to identify your machine on the network via a PC (for example with the name "PRINT- NETWORK-1").

1

Press

, select the menu SETUP using the keys

 

or

and confirm with OK.

 

 

2

Select WLAN using the keys or

and confirm

 

with OK.

 

 

3

Select PARAMETERS using the keys

or

and

 

confirm with OK.

 

 

4

Select HOSTNAME using the keys

or

and

 

confirm with OK.

 

 

5Type in the desired name (15 characters maximum) and confirm with OK.

6Exit this menu by pressing the key.

Once your connection has been set up, you must install

features

An example of how an AD-HOC network

the network printer driver on your PC so that you can print

 

your documents.

 

Refer to the paragraph Software installation, page 57.

 

may be set up

 

Network

Below is an example of how to configure an Ad-hoc

 

network without security protection using the following

 

parameters:

 

•

network name: "house"

-

•

radio type: "ad-hoc"

•

channel: "1"

9

• PC’s IP address: "169.254.0.1"

 

• PC’s subnetwork mask: "255.255.0.0"

 

•

PC’s gateway: "0.0.0.0"

 

• IP address of the multifunction machine: "169.254.0.2"

• subnetwork mask of the multifunction machine: "255.255.0.0"

• multifunction machine’s gateway: "0.0.0.0"

Setting up a machine

1Plug the WLAN USB key into the USB connector of the multifunction machine.

2

Press

, select the menu SETUP using the keys

 

or

and confirm with OK.

 

3

Select WLAN using the keys or and confirm

 

with OK.

 

4

Select CONFIG. ASS. using the keys

or and

 

confirm with OK.

 

5

Select NEW NETWORK using the keys

or

 

and confirm with OK.

 

6SSID appears on the screen, enter "house" using the numerical keypad and confirm with OK.

7Select the mode AD-HOC MODE and confirm with OK.

8Enter "1" in the field CHANNEL and confirm with OK.

9Select OFF and confirm with OK.

10Select IP CONF.: MANU and confirm with OK.

11Enter "169.254.0.2" in the field IP ADDRESS and confirm with OK.

12Enter "255.255.0.0" in the field SUBNET MASK and confirm with OK.

13Enter "0.0.0.0" in the field GATEWAY and confirm with OK.

14At the end of this process, you return to the main menu of ASS. CONFIG.

15 Exit this menu by pressing the key.

Once the network has been set up, the LED of the WLAN USB key should be on.

You must now set up the PC.

- 50 -

Page 54 Page 56
Image 55
Page 54 Page 56
Contents Xerox Phaser 3100MFP/X Dear customer Dear customerConsumables Contents Network features Parameters/SetupPC Features Customer Information Security Software use license Environment License Safety introductionSymbols SecurityOperational Safety Information Laser Safety InformationDo Not Do These Electrical Safety InformationElectrical Supply Used on electromechanical equipmentOzone Information Emergency Power OffMaintenance Information Disconnect deviceCertifications in Europe Product Safety CertificationRegulatory Information Regulatory information for the Fax functionCanada Product Recycling and Disposal LicenseLicense Environment Security Software useEH&S Contact Information Energy Program ComplianceNorth America USA, Canada Energy starSecurity directives Symbols for the main power switch Positions of Safety labels on the machineSoftware use license Prohibited reproductions Registered trademarksApplicable law Running environment InstallationInstallation Location conditionsSafety During Operation Safety informationHandling the machine Paper recommendationsRules for use symbols Machine Overview Control panel Accessing menusPaper tray installation Packaging contentsDevice installation Installing the document feederPush the lower panel down until it clicks Print cartridge installationDevice connection Device initial setupOutput Support Tab Starting your devicePaper in the main paper tray, page 15. Once paper has Loading paper in the manual feed trayRecommendations, Use of envelopes Simple copy ECO mode copyCopy CopyAdvanced FCT/COPY/RESOLUTION ID Card Copy modeSpecial setups for copying Resolution setupContrast setup Zoom setupCollated copy setup Scanned original setupPaper tray selection Paper type setupMargin Shift using the Document Glass Paper size setupPrint a cover sheet Delayed transmissionFax Fax transmissionRelay broadcast Default tray set to ManualFax Fax receptionPrinting fax messages stored in the memory Saving an access codeFax answering machine Fax reroutingPrinting rerouted documents Setting the re-direction contactRerouting fax messages to a USB memory key Transmission waiting queueMailBoxes MBX Fax Cancelling a transmission in progressPrinting the MBX list Modifying the features of a MBXPrinting the contents of a MBX Deleting a MBXFAX / Polling RX Deposit and PollingPlacing a document in deposit Polling a deposited documentPresentation of the sender SMSSMS Parameters Sending an SMSYour fax number/Your name Parameters SetupSummer time / Winter time setting Date/TimeType of network Geographical settingsLocal prefix Economy period Reception ModeTransmission report Document feed typeFax or PC reception Adjust toReception without paper Number of copiesTechnical Parameters Received faxes reduction modeSetup / Reception / Reduction Setup / TechnicalsTo print the logs Printing the functions guidePrinting the logs Print / Functions ListLock the machine Print the list of setupsRead the counters Display the consumables status Parameters/SetupCalibrate your scanner Directory DirectoryDirectory / SAVE/LOAD / Save Printing the directorySaving/Restoring the directory Smart card option Directory / PrintCalendar Print the solution to a gridGames Calendar SudokuRadio networks Wlan Network featuresNetwork features Type of radio networkConnect your Wlan adaptor Configure your networkCreating or rejoining a network Referring to or changing your network parameters Setup / Wlan / Parameters Hostname Setting up a machineMay be set up Setup / Wlan / Parameters / SecuritySetting up the PC Print your documents USB memory keyUSB memory key Use of the USB memory keyDelete your files stored on the key Read the USB memory key contentsKey Save a document on a USB memory KeyCreation Advanced FCT / Dect / Register Connecting the USB-DECT baseTelephony option Registering Dect handsetsAdvanced FCT / Dect / Ringing Time Customising telephony settingsTelephony option Unregistering Dect handsetSoftware installation PC FeaturesPC Features Configuration requirementsInstalling drivers only PC Features Connections Installing the drivers manuallyThis installation mode is only possible Installing the full software package,Uninstall the software from your PC Software UninstallationUninstall the drivers from your PC Graphical presentation Machine ManagementCompanion Director Checking the connection between the PC and the machineStatus of the connection Companion MonitorDevice management Selecting the current deviceScanning with Scan To Xerox Companion Suite featuresDocument scanning Display the consumable statusCharacter recognition software OCR Printing in duplex mode with the machinePrinting Printing to the machinePrinting Manage the address book Address bookAdd a contact to the machine’s address book Add a group to the machine’s address bookImport or export an address book Fax communications depending on modelPresentation of the Fax window Send a fax from the hard disk or the machine Send a faxSend a fax from an application Follow-up of fax communications Receive a faxDescription of the tab Logs and Reports Access to fax parametersDescription of the tab FAX Parameters FeaturesPC Fax parametersCreating a cover page template CoverFor the second step Creating a coverAdjust the size of your field so that Description of the tab Cover page FeaturesPCText is readable Click on the icon SMS Window MF SMS Communications depending on modelPresentation of the SMS window Send an SMSSent item memory items sent Access to SMS parametersFollow-up of SMS SMS ParametersGeneral information MaintenanceService Print cartridge replacementCleaning MaintenancePrinter cleaning Error messages Printer issuesPaper jam Miscellaneous problems ADF Feeding problemsPC printing via USB connection PC printing issuesPC printing via Wlan connection Firmware updateUpdating the machine firmware requires that the Xerox Environmental specifications SpecificationsPhysical specifications Electrical specificationsPrint cartridge Consumable specificationsCustomer Information Customer Information
Top Page Image Contents