Polycom RSS 4000, 3725-32870-002 manual Password Modification, Ping, Network Setting

Chapter 6 – Appendix A – Telnet/Terminal Commands

The default setting is telnet on. If "telnet off" is entered to disable the telnet function of

the Polycom® RSS™ 4000, user can only use the serial port to perform above system setting tasks. The default telnet port is 23, which cannot be modified. The password and command operations for remote telnet login are identical to those for serial port login.

Password Modification

Type "set telnet password" after the prompt "#" to modify the login password for the Command Setting page.

This command is only used to change the login password for the telnet session and serial interface. It does not impact the Web UI password.

Ping

Enter ping <ip> {-n<count>}{-w<time>}{-l<size>}after the prompt "#" to check the network connection status.

Table 6-2Parameters Description

Parameter

Description

ip	IP address of the destination host
-n<count>	Packet sending times, defaulted to 10
-w<time>	Waiting time, defaulted to 1000 ms
-l<size>	Size of the sent packet, defaulted to 32 bytes

[Example] Send the host whose IP address is 172.21.100.111 a Ping packet with the size of 1500 bytes for five times cyclically. The wait time is 1000 ms:

Network Setting

Enter the following commands after the prompt "#" to set network configurations:

“set {lan1 lan2} ip {dhcp static <ip> netmask <mask> gw <gateway>}” - set the IP address for LAN 1 or LAN 2.

6-4