Fuji Labs ZSP instruction manual Func

Page 28

8.7.1Current time setting

Set the current time and day of the week.

Press the FUNC key in the measuring status.

The AUTO CAL LED of the function indicating lamps will flicker.

The main indication shows the hour and minute via a 24-hour indication and the decimal point flickers. A’–’ bar lights up at the relevant weekday on the sub indication.

Indication

SU MO TU WE TH

FR

SA

Day

Sun. Mon. Tue. Wed. Thu.

Fri.

Sat.

Press the key and the time is now settable.

The highest two digits of the main indication will flicker.

The numeric value is incremented by pressing the ‘ ’.

Press the key and the digit can be selected.

After the time setting, press key and the day is settable on the sub indication.

The bar indication will flicker.

Press the key and the bar will shift.

Press the ENT key when the time and day setting is fin- ished. The data are saved.

Time starts from the point where ENT key is pressed.

FUNC

SU

TU

TH

SA

NO

 

 

 

MO WE FR

 

Flickers

 

 

AUTO CAL

 

 

 

(

 

 

)

SU

TU

TH

SA

NO

MO WE FR

( )

SU TU TH SA

NO

MO WE FR

ENT

SU TU TH SA

NO

MO WE FR

– 20 –

Image 28
Contents Infrared GAS Analyzer Introduction RequestProhibition Iii Prohibition Others Contents Vii Specifications OutlineComposition PreparedSelection of installation site InstallationSelection of gas sampling location Installation work Connection of cablesPiping procedure Injection of clean water Supply of external powerDescription of Each Part Preparation for OperationAirtightness test Setting of temperature inside lockerWarm-up time INDICATION/OPERATION Panel SO2Function and indication of indication/operation panel This panel consists of the following functionsAdvice on Operation General operation of indication/operation panelKinds of standard gas CalibrationPreparation of standard gas Pressure regulation for standard gas cylinder Calibration concentration setting except zirconia O2 sensor Func CAL SET ENTCAL Calibration concentration setting zirconia O2 sensor CAL Comp ENT Zero Single-component analyzer Auto calibration Auto CAL Func Auto CAL Func Auto CAL ENT Auto calibration ON/OFF setting Func Hold ENT Operating procedure OperationMaintenance Routine maintenance and inspectionConditioner Periodic maintenance and inspection Other maintenance and inspectionCentration is measured in the setting range of 0 to 200ppm or more at 0.5L/minMaintenance of sampling device Gas extractor type ZBAK1Membrane filter Exploded view of diaphragm type aspirator Structure of electronic dehumidifier Structure of NO2 /NO converter Structure of Permapure dryer Maintenance of zirconia O2 sensor Others, major component figuresStandard Accessories and Spares Standard accessoriesSpares for 1 year optional Code for preparation of 1-year spares and suppliesProcessing of Heating Pipe Ends OutlineEnd processing method Grid 300mm 40mm Grid area 150 mm Check after piping Clamp supportSpecifications of tube trace Specifications of heating pipeTroubleshooting Troubleshooting of instrumentError codes and remedies Ambient temperature Power supplyPower consumption Mass weightMonth/NO2, 100ppm Standard requirements For sample gasNumber of output points and kinds of outputs Block diagram Moving average outputAutomatic calibration Ordering informationCalibration tolerance Automatic calibration output hold Calibration cycle Once/day variable, up to 7 daysCode Symbols Diaglam Functions of individual components For outdoor installation type For indoor installation typeConnection Diagram Only specified outputs are wiredHead Office Instrumentation Div International Sales Dept