Fuji Labs ZSP instruction manual Outline, Specifications, Composition, Prepared

Page 9

1. OUTLINE

The infrared gas analyzer (ZSP) can continuously and accurately measure the concentration of gases such as NOx, SO2, CO, CO2 and O2 contained in the flue gas from a stationary generating source. The analyzer is available in both single-component and multi-component types depending on customer’s specification. The actual analyzer may somewhat differ from the descriptions in this manual depending on the specifications demanded by each customer. For outline diagram, piping system, hardware configuration, specifications, standard accessories, spares and supplies, refer to the delivery specifications submitted individually.

Note: For details of the infrared gas analyzer, refer to the instruction manual INZ-TN2 ZRG separately

prepared.

2. SPECIFICATIONS

Please refer to Chapter 14. Specifications. Note that the contents of the separately issued data sheet have priority.

3. COMPOSITION

(1)

Gas sampling section

1 set (depending on customers’ designation)

(2)

Gas piping

1 set (depending on customers’ designation)

(3)

Accommodation locker

1

 

 

Infrared gas analyzer ZRG

1 or 2 (depending on customers’ designation)

 

Zirconia O2 sensor ZFK 3, 4

1

(depending on customers’ designation)

 

Converter ZDL

1

(for NOx measurement)

 

Sampling

1 set

 

Standard gas, pressure regulator

1 set (depending on customers’ designation)

 

Standard accessories

1 set

 

Spares and supplies for 1 year

1 set (depending on customer’s designation)

– 1 –

Image 9
Contents Infrared GAS Analyzer Request IntroductionProhibition Iii Prohibition Others Contents Vii Outline SpecificationsComposition PreparedInstallation Selection of installation siteSelection of gas sampling location Connection of cables Installation workPiping procedure Supply of external power Injection of clean waterDescription of Each Part Preparation for OperationSetting of temperature inside locker Airtightness testWarm-up time SO2 INDICATION/OPERATION PanelThis panel consists of the following functions Function and indication of indication/operation panelGeneral operation of indication/operation panel Advice on OperationCalibration Kinds of standard gasPreparation of standard gas Pressure regulation for standard gas cylinder Func CAL SET ENT Calibration concentration setting except zirconia O2 sensorCAL Calibration concentration setting zirconia O2 sensor CAL Comp ENT Zero Single-component analyzer Auto calibration Auto CAL Func Auto CAL Func Auto CAL ENT Auto calibration ON/OFF setting Func Hold ENT Operation Operating procedureRoutine maintenance and inspection MaintenanceConditioner Other maintenance and inspection Periodic maintenance and inspectionCentration is measured in the setting range of 0 to 200ppm or more at 0.5L/minGas extractor type ZBAK1 Maintenance of sampling deviceMembrane filter Exploded view of diaphragm type aspirator Structure of electronic dehumidifier Structure of NO2 /NO converter Structure of Permapure dryer Others, major component figures Maintenance of zirconia O2 sensorStandard accessories Standard Accessories and SparesCode for preparation of 1-year spares and supplies Spares for 1 year optionalOutline Processing of Heating Pipe EndsEnd processing method Grid 300mm 40mm Grid area 150 mm Clamp support Check after pipingSpecifications of heating pipe Specifications of tube traceTroubleshooting of instrument TroubleshootingError codes and remedies Power supply Ambient temperaturePower consumption Mass weightStandard requirements For sample gas Month/NO2, 100ppmNumber of output points and kinds of outputs Moving average output Block diagramOrdering information Automatic calibrationCalibration tolerance Automatic calibration output hold Calibration cycle Once/day variable, up to 7 daysCode Symbols Diaglam Functions of individual components For indoor installation type For outdoor installation typeOnly specified outputs are wired Connection DiagramHead Office Instrumentation Div International Sales Dept