Fuji Labs ZSP instruction manual Automatic calibration, Ordering information, Display

Page 56

Automatic calibration

•Calibration tolerance:

•Automatic calibration output hold:

±0.2% FS Possible

(Example in 4 component analyzer):

CO zero

CO span

O2 zero

NOx, SO2 zero

NOx span

SO2 span

O2 span

Automatic calibration

• Calibration cycle:

Once/day (variable, up to 7 days)

•Calibration gas feed time:2 to 10 min. (variable), common to each gas

• Display:	Calibration failure
	Error code (E-) is displayed when one-time calibration volume is more
	than ± 20% FS on both zero and span and it is under calibration:

	CAL	lamp ON

Ordering information

1.Measuring range of analyzer

2.Length of sampling pipe

3.Insertion length of sampling tube

4.Power voltage/frequency

5.Instruction required when standard gas is not necessary

6.Instruction required when individual inspection is not necessary

7.Necessity of spares and supplies (for 1 year)

8.Additional functions

Note: When special functions such as remote range selection, output hold by external contact, auto- matic calibration, automatic calibration start by external contact, insulation output, measured value concentration alarm, etc. are required, they should be separately designated.

– 48 –

Image 56

Contents Infrared GAS Analyzer Introduction RequestProhibition Iii Prohibition Others Contents Vii Specifications OutlineComposition PreparedSelection of gas sampling location InstallationSelection of installation site Installation work Connection of cablesPiping procedure Injection of clean water Supply of external powerDescription of Each Part Preparation for OperationWarm-up time Setting of temperature inside lockerAirtightness test INDICATION/OPERATION Panel SO2Function and indication of indication/operation panel This panel consists of the following functionsAdvice on Operation General operation of indication/operation panelPreparation of standard gas CalibrationKinds of standard gas Pressure regulation for standard gas cylinder Calibration concentration setting except zirconia O2 sensor Func CAL SET ENTCAL Calibration concentration setting zirconia O2 sensor CAL Comp ENT Zero Single-component analyzer Auto calibration Auto CAL Func Auto CAL Func Auto CAL ENT Auto calibration ON/OFF setting Func Hold ENT Operating procedure OperationMaintenance Routine maintenance and inspectionConditioner Periodic maintenance and inspection Other maintenance and inspectionCentration is measured in the setting range of 0 to 200ppm or more at 0.5L/minMaintenance of sampling device Gas extractor type ZBAK1Membrane filter Exploded view of diaphragm type aspirator Structure of electronic dehumidifier Structure of NO2 /NO converter Structure of Permapure dryer Maintenance of zirconia O2 sensor Others, major component figuresStandard Accessories and Spares Standard accessoriesSpares for 1 year optional Code for preparation of 1-year spares and suppliesProcessing of Heating Pipe Ends OutlineEnd processing method Grid 300mm 40mm Grid area 150 mm Check after piping Clamp supportSpecifications of tube trace Specifications of heating pipeTroubleshooting Troubleshooting of instrumentError codes and remedies Ambient temperature Power supplyPower consumption Mass weightNumber of output points and kinds of outputs Standard requirements For sample gasMonth/NO2, 100ppm Block diagram Moving average outputAutomatic calibration Ordering informationCalibration tolerance Automatic calibration output hold Calibration cycle Once/day variable, up to 7 daysCode Symbols Diaglam Functions of individual components For outdoor installation type For indoor installation typeConnection Diagram Only specified outputs are wiredHead Office Instrumentation Div International Sales Dept