Olicom 9600 manual Date

9600 Compressor Installation, Operation, and Maintenance

CTI-CRYOGENICS

HELIX TECHNOLOGY CORPORATION

9.Ensure that the pressure gauge reads the proper value as shown in Table 4-1. If additional gas pressure is required, refer to Adding Helium within this section. If gas pressure needs to be reduced, refer to Reducing Helium Pressure within this section.

10.Record the adsorber replacement date on the label as shown in Fig- ure 5-2, and also note that the next adsorber replacement should be performed every three years.

DATE

ADSORBER

ADSORBER

MOUNTING

BOLT

Figure 5-2: Adsorber Location within the 9600 Compressor (Rear Panel Removed)

P/N 8040540 5-3