Shindaiwa 6850-9430, GP3410 manual Maintenance

Page 10

Maintenance

General Maintenance

IMPORTANT!

MAINTENANCE, REPLACEMENT OR RE- PAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY REPAIR ESTABLISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHO- RIZED BY SHINDAIWA CORPORATION. THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE OUT- COME OF A WARRANTY CLAIM.

Daily Maintenance

WARNING!

Before performing any maintenance, repair or cleaning work on the unit, make sure the engine and cutting attachment are completely stopped. Disconnect the spark plug wire before performing service or maintenance work.

WARNING!

Non-standard parts may not operate properly with your unit and may cause damage and lead to per- sonal injury.

NOTE:

Using non-standard replacement parts could invalidate your Shindaiwa warranty.

Muffler

This unit must never be operated with a faulty or missing spark arrester or muffler. Make sure the muffler is well secured and in good condition. A worn or damaged muffler is a fire hazard and may also cause hearing loss.

Spark Plug

Keep the spark plug and wire connections tight and clean.

Fasteners

Make sure nuts, bolts, and screws (except carburetor adjusting screws) are tight.

Prior to each work day, perform the following:

. Remove dirt or debris from the engine, check the cooling fins and air cleaner for clogging and clean them as necessary.

10-Hour Maintenance

(more frequently in dusty conditions)

. Remove the air filter cover by loosening the two thumbscrews. See Figure 13A.

. Remove and inspect the pre-filter. If the pre-filter is torn or otherwise dam- aged, replace it with a new one. See Figure 13B.

3.Clean the pre-filter with soap and water. Let dry before reinstalling.

4.Inspect the air filter element. If the ele- ment is damaged or distorted, replace it with a new one.

5.Tap filter gently on a hard surface to dis- lodge debris from element or use com- pressed air from the inside to blow debris out and away from the air filter element.

IMPORTANT!

Direct the air stream at the inside face of the filter only!

. Carefully remove any accumulation of dirt or debris from the muffler or the fuel tank. Dirt build-up in these areas could cause engine overheating, induce premature wear, or create a fire hazard.

Loosen

thumbscrews

Figure 13A

6.Install the filter element, pre-filter and cover in the reverse order of removal.

3.Check for loose or missing screws or components.

4.Check the entire unit for leaking fuel.

Pre-filter

Filter

Element

Figure 13B

CAUTION!

Never operate the unit if the air filter assembly is damaged or missing!

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents GP3410 Water Pump Contents IntroductionUse Good Judgment General Safety InstructionsSafety labels Minimize the Risk of FireSpecifications Unit DescriptionInstall the Suction and Discharge Hoses AssemblyPrior to Assembly PrimingFilling the Fuel Tank Mixing FuelExample of 501 mixing Quantites Never start the engine from Operating position When the Engine StartsStarting the Engine If the engine does not startIdle Speed Adjustment Adjusting Engine IdleStarting a flooded engine Operating Tips for Maximum Performance Discharge Quantity liters per minuteMaintenance 10/15-Hour Maintenance Every 10 to 15 hours of operationValve Adjustment 139/150-Hour MaintenanceMaintenance after first 139-hours Then every 150-hours thereafterSpark Arrester Maintenance Long Term StoragePossible Cause Troubleshooting GuideSymptom RemedyIs the engine overheating? Engine is knockingEngine difficult to shut off Poor accelerationEngine stops abruptly Excessive vibrationThis Warranty is Administered by Page Page Page Bomba de agua GP3410 Introducción Notas de especial interés ÍndiceInstrucciones generales de seguridad Etiquetas de SeguridadDescripción de la unidad EspecificacionesInstalación de las mangueras de aspiración y de descarga MontajeAntes del montaje CebadoLlenado del depósito de combustible Mezcla de combustibleEjemplo de mezcla en Proporción de Cuando el motor arranque Arranque del motorSi el motor no arranca Arranque de un motor ahogado Arranque del motor continuaciónAjuste del ralentí del motor Ajuste de la velocidad de ralentí100 150 200 250 300 Consejos de utilización para obtener el máximo rendimientoCaudal de descarga litros por minuto Mantenimiento Mantenimiento cada 50 horas Mantenimiento cada 10 o 15 horasCada 10 o 15 horas de uso Cada 50 horas de funcionamientoMantenimiento cada 139 o 150 horas Ajuste de la válvulaAlmacenamiento a largo plazo Mantenimiento del guardachispasSíntoma Posible causa Remedio Guia Diagnostico continuaciónQué revisar Qué revisar Posible causa Remedio Difícil apagado del motor Deficiente aceleraciónEl motor se detiene abruptamente Excesiva vibraciónEsta Garantía ES Administrada POR Notas SP19 Asaminami-Ku, Hiroshima Pompe À EAU GP3410 Table des matières Introduction Mises en gardeUn énoncé précédé de la mention Mesures de sécurité générales Étiquettes de sécuritéDescription de l’appareil Caractéristiques techniquesAvant l’assemblage Installation des tuyaux d’aspiration et de refoulementAssemblage Amorçage de la pompeRemplissage du réservoir de carburant Mélange de carburantExemples de quantités de mélange de carburant à Lorsque le moteur démarre Démarrage du moteurSi le moteur ne démarre pas Démarrage d’un moteur noyé Démarrage du moteur suiteRéglage du ralenti du moteur Réglage du ralentiIl est recommandé de porter des gants Conseils d’utilisation pour des performances optimalesEntretien Entretien toutes les 10 à 15 heures Entretien suiteEntretien toutes les 50 heures Toutes les 150 heures ultérieures Entretien toutes les 139 à 150 heuresEntretien aux 139 heures, puis Réglage du jeu des soupapesRemisage à long terme Entretien du pare-étincellesProblème SolutionGuide de dépannage Cause probableLe moteur surchauffe-t-il ? Guide de dépannage suitePoints à contrôler Le moteur cognePoints à contrôler Cause probable Solution Shindaiwa Corporation Remarque FR19 Shindaiwa Inc 11975 S.W. Herman Rd
Top Page Image Contents