Danby SPAC8499 manual DRY Dehumidifier Operating Instructions, Temperature

DRY (Dehumidifier) Operating Instructions

1)Press the I/O (on/off) key pad to switch on the unit.

2)Press the MODE key until the word DRY (Dehumidifying) is displayed in the LCD display window. Fig. 17. Each depression of the MODE key will advance to a different mode setting (Cool-Heat-Dry-Fan).

3)Press the appropriate orkey to set a dehumidifying temperature between

10°C (50°F) to 30°C (88°F). Fig. 18. The green indicator light will come on indicating the dehumidifying mode is operational (there may be a slight delay of 10-30 seconds before the cycle begins, this is normal).

IMPORTANT: The temperature selected

should always be set a few degrees lower than the room ambient temperature, to ensure normal dehumidifying operation. However, it is not recommended to operate your Dehumidifier,

Water Full

Cool/Heat/Dry

Green Light

TIMER ON	12:00	I/O	MODE
MODE	DRY	FAN	ON
FAN SPEED HIGH
		SWING	TIMER
	00
TEMP.			OFF

Dry Mode

Fig. 17

below temperatures of 15.5°C (60°F), this could result in icing-up conditions of the evaporator coils, minimizing efficiency. Under the dehumidifying mode, you cannot select a fan speed. The fan motor operates at a pre-set speed, which registers as MED in the LCD window.

4)Condensed water will be accumulated in the water tank. When the tank is full, the unit will sound a signal (8 beeps) and the Water Full indicator light start flashing. At this time the dehumidification process will immediately stop. However, the fan motor will continue to operate (this is normal). Carefully remove the water tank from the cabinet and dispose of the water. Replace the water tank back to it’s original position (in cabinet) and the Dehumidifying process will automatically resume. It may take

3-5 minutes for the compressor to re-start. This is normal.

5)This unit also has provisions for a continuous “drain” option (for basement applications having a floor drain). The required drain hose extension is not included with this unit. It can be purchased through any local Hardware Store. Drain Hose Specifications: Standard garden hose.

		12:00	I/O	MODE
					TEMP./CLOCK
MODE		DRY			ADJ.
			FAN	ON
FAN SPEED	MED
				TIMER
	TEMP.	10¡c
			SWING	OFF	CLOCK
Temperature
					Fig. 18

11