Kenmore 15358 owner manual Extension Table, Changing Needle, Free-arm

Extension Table

•Detaching the table

Pull the table away from the machine, as illustrated, for "flee-arm" sewing of cuffs and sleeves. The extension table can be used as accessory box.

•Attaching the table

Push the extension table until it snaps into the machine.

/\

L!; Extension table :12)Pin

_3) Holes

(4)Tab

(&',Free-arm

Changing Needle

f_

,!/Needle clamp screw

(2) Needle clamp

[] Turn off the power switch.

Raise the needle to its highest position by turning the handwheel counterclockwise, toward you, and lowering the presser foot. Loosen the needle clamp screw0_ by turning it counterclockwise. Remove the needle from the needle clamp (2).

[] Insert a new needle into the needle clamp _2)with the flat side to the rear. When inserting the needle into the needle clamp'S2),push it up as far as it goe

the needle clamp screw _1_firmly, by turn [] To see if the needle is good, place the

needle onto something flat (e.g needk

The gap between the needle and the be consistent. Never use a bent or

A damaged needle in knits, fine silks

To Remove	and Attach the Foot Holder	f
(i) Set screw
(2) Foot holder
(3) Presser bar
• To remove

Remove the set screw _i) by turning it counterclock- wise with a screwdriver.

•To attach

Match the hole in the foot holder (2) with the threaded hole in the presser bar (3). Fit the set screw _i) into

the hole. Tighten the screw _i) by turning it clockwise with a screwdriver.

\

Flat side

Lado piano

.... Meplat

\

\\\\

Needle

Aguja

Aiguille

/// ......

,/ /'

///

J

-x

10