Kenmore 15358 owner manual To sew, Rolled Hem Sewing

Zipper Sewing (Continued)

• To sew	[]
_1_1/8" (0.4cm) fabric margin
, 2Zipper,	teeth
IXt 1)_
_3_Zipper tape
@_Forward edge of zipper foot
/-\	direction
,5, Sewing

[] Fold back the upper layer seam allowance. Fold back

the lower layer seam allowance to leave a 1/8" (0.4 cm) margin of fabric _1_,.

Place zipper teeth next to margin edge and pin margin to zipper tape.

•	f_,	,
Align forward edge of zipper foot _4j'.wlthmargin edge.
Return thread tension and stitch length to original
settings. Sew a seam the entire length of zipper tape,
removing pins as you go. Before reaching pull-tab, unzip
a few inches to clear a path for the stitch. Remove fabric
and close zipper.		[]

[] Take the upper fabric layer and lay it flat over the zipper. Beginning above pull-tab at top of zipper tape, sew a seam about 3/8" to 1/2" (approx. 1.3 cm) distance from the basting stitches. Stop sewing at a position just below

the zipper bottom stop.

Turn fabric 90° and sew to meet the bottom seam. Sew in reverse a few stitches to lock.

Once both sides of zipper are sewn, use seam ripper to open the basting stitch.

Rolled		Hem	Sewing
_1_ Stitch pattern selector:				1
_2_ Presser foot:				e
._3"Needle, thread tensi
@	Stitch	length:
TO	sew:
Fold the edge				in length
and 0.3 cm (1/8")
Trim the corner			0.5	for easier
insertion		of the	hem

_,_1Wrong Side of the ,_2_0.5 cm (3/16") _.3_0.8 cm (1/4")

_4_ Curl of the Foot

Place the fabric aligning the edge of hem with the guide on the foot.

Lower the foot and sew to 1-2 cm (1/2"-1") while pulling both threads to the back.

Stop the machine and lower the needle into the fabric.

Raise the foot and insert the folded portion of the fabric into the curl of the foot.

Lower the foot, and then sew by lifting up the edge of the fabric to keep it feeding smoothly and evenly.

(3/8"~1/2")

)fox. 1.3 cm)

4O