Kenmore 15358 owner manual Buttonhole, To5, 25-1

SECTION Vl. BUTTONHOLE

Buttonhole

_i_ Pattern	selector:	[! (BH)
_2_Presser foot:		Automatic buttonhole foot
_3_Thread	tension:	1 to5
_4_Stitch length:		(0.25-1)

*The size of buttonhole is automatically set by placing the button in the automatic buttonhole foot.

*The button holder of the foot takes a button size up to

2.5cm (1") in diameter.

*Make a test buttonhole on a sample duplicating the fabric, interfacing and seams of the actual garment.

*Place the button on the garment fabric and mark the top and bottom to determine the position of buttonhole.

*Use interfacing on stretch fabrics.

[] Turn the handwheel toward you to raise the needle to its highest position.

Raise the presser foot lifter.

[] Select the pattern "BH" by turning the pattern selector dial.

If the BH pattern is already selected, reset the dial once

according to the procedure in/_.

[] Attach the automatic buttonhole foot.

[]	Pull the button holder to the			back, and
	in it. Push back the button holder toward
	it will	go.
[] Pull the buttonhole			lever
		Buttonhole
[]	Insert	fabric
	Turn	the		0Ur
	hand	until the		turning
	handwheet until the			st position.
[]	Remove the fabric		to	_ads to
	the left.
[]	Insert the garment		under	the needle

at the starting point.

Then lower the automatic buttonhole foot.

Note:

Make sure there is no gap between the slider and the spring holder. If there is a gap, the length of the rows will be different, as shown.

(:_ Starting point

(:_ Slider

There should be no gap

Spring holder

Difference

_\1 jJ

BH

II

[]%%

%[]%

®

®

®

64