Chapter 2 Fault Descriptions
Access Point /Bridge Faults
Table | Access Point Faults (continued) |
|
| |
|
|
|
| |
Fault Description | Explanation | Related Setting | Recommended Action | |
|
|
|
| |
Ethernet bandwidth | The fault threshold set for the | Manage Fault | Verify that the fault threshold is set | |
utilization is Degraded | degraded state has been exceeded. | Settings > Access | correctly. | |
(utilization %) |
| When this fault is cleared, the | Point/Point | If the threshold is set correctly, review |
|
| Thresholds > | ||
|
| following message displays: Ethernet | your network to determine the action | |
|
| bandwidth utilization is OK. | Ethernet Port | necessary to clear the fault condition. |
|
| Utilization | ||
|
|
|
| |
|
|
|
| |
Ethernet bandwidth | The fault threshold set for the | Manage Fault | Verify that the fault threshold is set | |
utilization is |
| overloaded state has been exceeded. | Settings > Access | correctly. |
Overloaded |
| When this fault is cleared, the | Point/Bridge | If the threshold is set correctly, review |
(utilization %) |
| Thresholds > | ||
| following message displays: Ethernet | your network to determine the action | ||
|
| bandwidth utilization is OK. | Ethernet Port | necessary to clear the fault condition. |
|
| Utilization | ||
|
|
|
| |
|
|
|
| |
Excessive frame counts: | See IDS (Intrusion Detection System) Faults, page |
| ||
•Action
•Association
•Authentication
•Deauthentication
•Disassociation
•Probe
•Reassociation
Firmware version | The wrong version number for policy | Manage Fault | Make sure that the firmware version |
policy violation | checking has been entered. | Settings > Access | that is entered in the policy setting |
(version number) | When this fault is cleared, the | Point/Bridge | matches the firmware version on the |
| Policies > | access point. | |
| following message displays: | ||
| Firmware Version |
| |
| Firmware version is valid. |
| |
|
|
| |
|
|
|
|
| The access point is running an |
| Make sure that you have entered |
| unauthorized firmware version. |
| authorized versions in the policy |
| When this fault is cleared, the |
| setting. |
|
|
| |
| following message displays: |
| Update the firmware on the access |
| Firmware version is valid. |
| point to an authorized version. |
|
|
|
|
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine
|
| ||
|
|