Cisco Systems OL-8376-01 manual Radio Interface Faults

Chapter 2 Fault Descriptions

Radio Interface Faults

Table 2-1	Access Point Faults (continued)
Fault Description		Explanation	Related Setting	Recommended Action
WEP is disabled		WEP is not enabled for the VLAN	Manage Fault	Make sure you have set the policy
		defined on the access point. (Note	Settings > Access	correctly for the VLAN.
		that the VLAN number is displayed	Point/Bridge
		in the Type column under Faults >	Policies > WEP per
		Display Faults.)	Vlan
		When the fault is cleared, the
		following message displays: WEP is
		enabled.
WLSE failed to		Authentication required to open a	Manage Fault	Verify that the WLSE credentials used
authenticate with WDS.		WLCCP channel between the WLSE	Settings > WDS >	to authenticate with the WDS are
		and the WDS failed.	Authentication	correct.
			Failures	For more information, see the
				managing devices information in the
				online help or the User Guide for the
				CiscoWorks Wireless LAN Solution
				Engine, Release 2.13.

Radio Interface Faults

Table 2-2	Radio Interface Faults
Fault Description		Explanation	Related Setting	Recommended Action
AP is in a Degraded		The fault threshold set for the	Manage Fault	Verify that the fault threshold is set
state number associated		degraded state has been exceeded.	Settings >	correctly.
clients		When this fault is cleared, the	Radio-802.11x	If the threshold is set correctly,
			Thresholds >
		following message displays: AP is		review your network to determine the
		in OK state.	Associated Clients	action necessary to clear the fault
				condition.
AP is in an Overloaded		The fault threshold set for the	Manage Fault	Verify that the fault threshold is set
state number associated		overloaded state has been	Settings > Thresholds	correctly.
clients		exceeded.	> Access Point >	If the threshold is set correctly,
			Associated Clients
		When this fault is cleared, the		review your network to determine the
		following message displays: AP is		action necessary to clear the fault
		in OK state.		condition.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-8 OL-8376-01