Chapter 2 Fault Descriptions
Router Fault
Router Fault
Table | Router Fault |
|
| |
|
|
|
| |
Fault Description | Explanation | Related Setting | Recommended Action | |
|
|
|
|
|
Device was not |
| The SNMP Agent on the switch is | Manage Fault | Make sure that the router SNMP agent |
reachable via SNMP | down. | Settings > Router > | is active. | |
|
| When this fault has been cleared, the | SNMP Reachable |
|
|
| following message displays: Device |
|
|
|
| was reachable via SNMP. |
|
|
|
|
|
|
|
WLSM Faults
Table | WLSM Faults |
|
| |
|
|
|
| |
Fault Description | Explanation | Related Setting | Recommended Action | |
|
|
|
|
|
Device was not |
| The SNMP Agent on the WLSM is | Manage Fault | Make sure that the SNMP agent is |
reachable via SNMP | down. | Settings > WLSM | active. | |
|
| When this fault has been cleared, the | > SNMP Reachable |
|
|
| following message displays: Device |
|
|
|
| was reachable via SNMP. |
|
|
|
|
|
| |
WLSM HSRP state | A switchover has occurred and the | Manage Fault | Investigate the reason for the | |
has changed to Active | standby WLSM has become active. | Settings > WLSM | switchover. For example it could have | |
|
| If the WLSM goes back to standby | > HSRP Standby to | been caused by any of the following |
|
| Active | reasons: the active WLSM might have | |
|
| state, the WLSE will automatically | ||
|
|
| become defective, it may have been | |
|
| clear the fault. |
| |
|
|
| physically pulled out of the chassis, or | |
|
| Note See the Recommended |
| |
|
|
| the configuration may have been | |
|
| Actions column for |
| modified. |
|
| information regarding |
| After the reason for the switchover has |
|
| clearingthe fault manually or |
| |
|
|
| been determined, schedule an inventory | |
|
| acknowledging the fault |
| |
|
|
| job to synchronize the current HSRP | |
|
| when the the WLSM does not |
| |
|
|
| states of the WLSMs. After inventory is | |
|
| go back to the standby state. |
| |
|
|
| complete, either move the fault to the | |
|
|
|
| |
|
|
|
| Acknowledge state or clear it. |
|
|
|
|
|
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine
|
| ||
|
|