Cisco Systems OL-8376-01 manual Voice Faults, Wlse Faults, Threshold%

Chapter 2 Fault Descriptions

Voice Faults

Voice Faults

Table 2-4	Voice Faults
Fault Description		Explanation	Related Setting	Recommended Action
Voice Bandwidth Exceeded		This is a warning that is	Faults > Manage	You can (at the expense of data traffic
[Bandwidth In		triggered only when the voice	Fault Settings, then	clients such as laptops) increase the
Use:current%,Threshold:		bandwidth in use exceeds the	Edit the Default	amount of bandwidth reserved for
threshold%]		threshold limit.	profile. Select	voice traffic. But a better solution
		The higher the percentage of	RADIO-802.11a	would be to find a solution that would
			THRESHOLDS >	reduce the voice traffic on the
		bandwidth being used, the less is
		available for new phone calls to	Voice Bandwidth.	congested cell.
		be placed or to roam in. The
		default configured bandwidth for
		voice is 75%. After reaching
		100% of the configured
		bandwidth in use, no additional
		calls can be accepted.

WLSE Faults

Table 2-5	WLSE Faults
Fault Description		Explanation	Related Setting	Recommended Action
Auto Resite Survey		There is at least one floor with a	Radio Manager >	Select the document with the eyeglasses in
Performance		20% difference in the base and	Auto Re-Site	the detail view of the fault condition. A list
Degradations		current performance values on one	Survey	of all buildings and floors that have
		or more floors configured for Auto		performance degradations is displayed.
		Re-Site Survey.		First, check the details for the floor and if
		The fault will clear when there are		needed, run Radio Manager Assisted
		no longer any buildings or any		Configuration. Then select Auto Re-Site
		floors with 20% differences in the		Survey to set the new base values.
		performance values.
Data may not have		The standby WLSE has detected a	Not applicable.	Make sure the WLSEs are correctly
been successfully		failure in the active WLSE and is		configured and functioning properly.
restored from active.		becoming active before it
		successfully synchronized with the
		active WLSE.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-24 OL-8376-01