PBX Networking | Configuration |
|
|
■If all the lines in bundle “C” are busy, the system tries to set up a connection via bundle “E”. PBX 3 switches the connection through, provided it is appropriately configured (refer to Numbering starting on page 95).
■If it was not possible to set up an indirect connection via PBX 3, the system tries again via bundle “A”. The “prefix” necessary for this can be configured with the route.
■The user does not get a busy signal until the attempt to set up an indirect con- nection via the network operator has also failed.
Note: If an internal connection is switched via a network op- erator, the call is signalled using the external number of the calling PBX.
For each route you can define a randomly selectable code digit for seizing the route. You can also configure whether a user is authorised to seize a particular route, whether LCR is to be used for one of the bundle and the criteria (business or private call, booking numbers) for evaluating call data.
9.2.3 Numbering
A user can seize a particular route by
If none of the telephone numbers in your PBX network occur twice, you can also configure “closed numbering”, allowing the same telephone number to be used for reaching each user within the PBX network.
With closed numbering, the Aastra 800 determines which route to seize from the telephone number dialled. The information needed for routing a call can be con- figured in a numbering table. You use this table to assign telephone numbers and/ or ranges of telephone numbers to a particular route.
A default entry in the numbering table makes it possible to seize a “default route” for all remaining unassigned numbers. In particular, this simplifies configuration of the Aastra 800 as a subsidiary system: the only entry you assign to the default entry is the route to the host system
95
