Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring the 10/100 Ethernet and GigE Modules 105
Configuring the 10/100 Ethernet and GigE Modules
The Cuda 12000 allows you to configure duplex mode for interfaces on the
10/100 module and the interface on the GigE modules. The Cuda 12000
also allows you to configure speed for interfaces on the 10/100 module.
You may set duplex mode to full duplex, half duplex, or auto negotiation.
You may set the speed of the 10/100 module to 10 Mbps, 100 Mbps, or
auto negotiation. By default, the Cuda 12000 sets duplex mode and speed
for auto negotiation.
You use the following commands to change duplex mode and speed
settings:
Refer to the Cuda 12000 IP Access Switch CLI Reference G uide for more
information on these commands.
Task Command
1. Enter interface configuration
mode for the Ethernet interface.
interface <c/s/i>
2. Set interface duplex mode. duplex {half | full | auto}
3. Set interface speed. speed {10 | 100 | auto}
4. Enable interface auto
negotiation.
negotiation auto
5. Disable interface auto
negotiation.
no negotiation auto