ADC 3 For more information on these commands, refer to the Cuda 12000 IP

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring RIP 295
For more information on these commands, refer to the Cuda 12000 IP
Access Switch CLI Reference Guide.
Several of the ip rip commands have no forms that enable you to perform
the following tasks from within IP address configuration mode:
15.Configure the authentication type
for the interface. When RIP is
enabled for the first time on the
interface, no authentication is in
effect by default.
ip rip authentication
{md5 | password}
16.Configure the authentication key
for the interface.
ip rip authentication {key-id <id>
key <key> | key <key>}
17.Verify the RIP configuration on the
current interface.
show ip rip
Task Command
1. Remove RIP from the interface. Refer to “Removing RIP from IP
Interfaces” on page 297.
2. Disable acceptance of host routes. no ip rip accept host-route
3. Disable acceptance of default
routes.
no ip rip accept default-route
4. Stop advertising the default route
only.
no ip rip send default-only
5. Stop advertising the default route
in addition to other routes.
no ip rip send default-also
6. Disable split horizon. no ip rip split-horizon
7. Disable poisoned reverse. no ip rip poisoned-reverse
8. Delete a static neighbor address. no ip rip neighbor <ip-address>
9. Disable authentication. no ip rip authentication
Task Command