ADC Telecommunications, Inc.
158 CHAPTER 8: TIMING AND ALARM CONTROLLER MANAGEMENT
To configure the alarm signals for transmit over the DB-15 connector and the associated signals that can trigger them, perform the following tasks. By default, all faults are configured to not send out their associated alarm signals over the DB-15 connector:
Power Alarm ■local-pwr-a-fault
■local-pwr-b-fault
■backplane-pwr-fault
■backplane-pwr-a-fault
■backplane-pwr-b-fault
■ps-ac-fault
■ps-dc-fault
Temp Fault ■processor-temp-fault
■ps-temp-fault
■fan-temp-fault
Power Fault ■local-pwr-a-fault
■local-pwr-b-fault
■backplane-pwr-a-fault
■backplane-pwr-b-fault
■ps-ac-fault
■ps-dc-fault
PowerA Fail ■local-pwr-a-fault
PowerB Fail ■local-pwr-b-fault
Clock ■bits-a-fault
■bits-b-fault
■red-alarm-fault
You Can Configure This
Signal: To Provide Notification of These Faults: