ADC Telecommunications, Inc.
18 CHAPTER : ABOUT THIS GUIDE
Part III: IP Routing
Chapter 11: Creating Route Filters — Provides information and
procedures for creating RIP and OSPF policy-based route filters.
Chapter 12: Configuring DHCP Relay — Provides information and
procedures on how to configure DHCP relay on a cable interface.
Chapter 13: Configuring DHCP Authority — Provides information and
procedures on how to configure DHCP authority on a cable interface.
Chapter 14: Configuring IP — Provides information and procedures on
how to configure IP routing on your system. Includes information on
Open Shortest Path First (OSPF) and Routing Information Protocol (RIP)
configuration.
Chapter 15: IP Packet Filtering — Provides information and procedures
for creating packet filters for cable interfaces.
Chapter 16: Network-Layer Bridging — Provides information and
procedures for creating network-layer bridge groups. These bridge
groups allow you to associate the same IP address with multiple system
interfaces. A key value of this feature is the ability to span a single subnet
across multiple system modules.
Chapter 17: Managing IP Multicast — Provides information and
procedures for configuring the Cuda 12000 to route multicast traffic,
which delivers a single stream of information to m ultiple destinations at
one time. Includes information on IGMP and multicast routes.
Part IV: Cable Modem Termination Systems
Chapter 18: Configuring Cable Modem Termination Systems —
Provides information and procedures for configuring and managing
CMTS RF parameters. Provides instruction on the configuration of
downstream and upstream channels, admission control, and advanced
CMTS parameters.
Chapter 19: Managing Cable Modems — Provides information for
managing and monitoring cable modems on the network.
Chapter 20: Subscriber Management — Describes how to configure
subscriber traffic filtering and Customer Premise Equipment (CPE) device
management on the Cuda 12000.
Chapter 21: MIB Browsing — Provides information on how to browse
cable modem and MTA MIBs and the MIB objects that are returned.