ADC Telecommunications, Inc.
308 CHAPTER 14: CONFIGURING IP
Configuring OSPF Parameters for an IP Interface

After you have entered IP address configuration mode and assigned an

area ID to the IP interface, you can then configure OSPF parameters on the

interface.

To do so, perform the following tasks within IP address configuration mode:

Task Command
1. Configure the cost for this OSPF
interface.
ip ospf cost <number>
2. Configure the dead-interval for th is
OSPF interface, in seconds. When
OSPF is initially enabled on the
interface, the dead interval defaults to
40 seconds.
The Cuda 12000 and all of its OSPF
neighbors on the IP interface you are
configuring must have matching dead
interval values. Otherwise, the
neighbors cannot form adjacencies.
ip ospf dead-interval <seconds>
3. Configure the Hello interval for th e
current OSPF interface, in seconds.
When OSPF is initially enabled on the
interface, the hello interval defaults to
10 seconds.
The Cuda 12000 and all of its OSPF
neighbors on the IP interface you are
configuring must have matching hello
interval values. Otherwise, the
neighbors cannot form adjacencies.
ip ospf hello-interval <seconds>