Cuda 12000 IP Access Switch CLI-based Administration Guide
Browsing Cable Modem and MTA Status 525
Browsing Cable Modem and MTA Status

The Cuda 12000 supports the retrieval and display of status information that

is maintained by individual cable modems and MTAs connected to the HFC

network. This information is useful when you have to monitor the network

and troubleshoot network problems.

To retrieve and display this status information:

1. Issue the interface <c/s/i> command to access interface mode for the

CMTS interface used by the cable modems and MTAs of interest.

2. Issue show modem commands (with the appropriate arguments) to

retrieve this information, as shown in the following table:

Table21-3 Commands for Accessing Ca ble Modem and MTA MIB Tables
Command MIB Table or Group
show modem <mac address> cm mac CM MAC (docsIfCmMacTable).
Refer to Table21-4 on pag e 528.
show modem <mac address> cm
service
CM Service
(docsIfCMServiceTable). Refer to
Table21-5 on page 528.
show modem <mac address> cm status CM Status (docsIfCMStatusTable).
Refer to Table21-6 on pag e 529.
show modem <mac address> cm
downstream
Downstream
(docsIfDownstreamChannelTable).
Refer to Table21-7 on pag e 530.
show modem <mac address> cm
upstream
Upstream
(docsIfUpstreamChannelTable).
Refer to Table21-8 on pag e 531.
show modem <mac address> cm
signal-quality
Signal Quality
(docsIfSignalQualityTable). Refer to
Table21-9 on page 532.
show modem <mac address> cm
qosprofile
QOS (docsIfQosProfileTable). Refer
to Table21-10 on page 533 .
show modem <mac address> cm
bpi-base
BPI Base (docsBPICMBaseTable).
Refer to Table21-11 on page 534.
show modem <mac address> cm
bpi-tek
BPI TEK (docsBPICMTEKTable).
Refer to Table21-12 on page 538.