3
| OPERATION |
AUTO CONTINUE
Current Mode
Beac Level
Beac Freq
El Angle
Az Angle
Pol Angle
Local
New Mode
Standby
Home
Manual /Stow
Goto
Auto Continue
Auto
New
Model
1 |
2 |
3 |
4 |
5 |
6 |
puts the antenna control system into STANDBY mode and skips to the HOME menu
skips to the Home (root) menu
moves to the Manual/Stow menu
moves to the 1st ‘Goto’ menu ie Goto Position
resumes tracking using the INTRAC’S current model
clears the INTRAC’S current model and starts learning a new model
Path | HOME - NEW MODE - MENU KEY 5 |
Description | This facility does not have a screen of its own. It is a function |
| enabled by a menu key on the New Mode menu. |
| If the INTRAC had been in Learning or Tracking mode and |
| had been taken out of that mode, and the model was still |
| valid, pressing Auto Continue will return the INTRAC to that |
| mode. |
| The antenna may have been stowed or moved off satellite for |
| some other reason. Alternatively the INTRAC may have gone |
| into Standby due to an alarm. In either case (once the |
| antenna has been unstowed) pressing Auto Continue will |
| cause the antenna to drive back to the satellite and continue |
| Learning or Tracking. |
| If the INTRAC had been Tracking but the time off satellite was |
| too long for the model to be relied on it will restart in Learning |
| mode to build a new model. |
Note | Until and unless the orbit model is cleared pressing Auto |
| Continue will cause the antenna to be driven to the satellite of |
| that model. Thus if a new satellite is required to be tracked |
| the antenna must be driven to that satellite’s location and |
| “Auto New Model” used to cause the INTRAC clear the |
| existing model and start to build a new one. |
| (see Auto New Model on the next page) |
© 2011 Advantech Wireless | Page 19 |
