FUNCTION (Configuration)
3
OPERATION
| Current Mode | Tracking | Function |
| |||||
|
| ||||||||
|
|
| |||||||
Standby |
| ||||||||
| Control State | Local |
| ||||||
| Beac Freq | 11.452000 GHz |
|
| |||||
| Beac Level |
|
| ||||||
|
| ||||||||
| El | Angle | 25.37 |
|
| Home |
| ||
| Az | Angle | 210.50 |
|
|
| |||
| Pol | Angle | 27.4 |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Models |
|
|
|
|
|
|
|
|
|
|
|
|
|
| > Beacon Pol not avail < | Test |
| ||||
|
|
|
| ||||||
|
|
| Beacon Frequency | Diags |
| ||||
|
|
| Edit Satellite Table |
|
| ||||
|
|
| System |
| |||||
|
|
| Soft Limits |
| |||||
|
|
| x2 Setup |
|
|
| Setup |
| |
|
|
| Diagnostics On |
|
| ||||
|
|
| Next |
| |||||
|
|
| Diagnostics Off |
| |||||
|
|
| Beacon Threshold | Field |
| ||||
| Press EN to accept selection |
|
| ||||||
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 |
2 |
3 |
4 |
5 |
6 |
puts the antenna control system into STANDBY mode and skips to the HOME menu
skips to the Home (root) menu
skips to the Models menu
controls whether ‘Angles’ or ‘Diagnostics’ appear on Test Port 1
skips to the System Setup menu
moves the highlight box to the next field in the current menu
Path | HOME - MENU KEY 4 |
Note | There are three separate menus under the FUNCTION |
| heading. Pressing Menu Key 4 (FUNCTION) on the “Home“ |
| menu leads to the CONFIGURATION menu from which the |
| MODELS menu and the SYSTEM SETUP menu are reached |
| via Menu Keys 3 & 5 respectively. |
| This Configuration menu can also be reached by Menu Keys |
| from the MODELS & SYSTEM SETUP menus |
Description | The Configuration menu contains seven sub menus plus |
| Diagnostics On & Off. |
| The sub menus are described on the following pages. |
| The Diagnostics On & Off keys are used to route the INTRAC |
| diagnostic data to the Remote Control port. This facility |
| enables one PC to be used as both the remote control |
| terminal and the diagnostics receiving terminal. However it |
| cannot do both at the same time. |
| WHEN IT IS REQUIRED TO CONTROL THE INTRAC FROM |
| THE REMOTE TERMINAL DIAGNOSTICS MUST BE |
| SWITCHED OFF. |
Menu Key 4 | Test Port - 1 Diags (Angles) |
| The data available at Test Port - 1 is either INTRAC |
| diagnostic data (the same diagnostic data as mentioned |
| above) or angles data. Selection between these two is by |
| Menu Key 4 whose label toggles between “Diags” & “Angles” |
© 2011 Advantech Wireless | Page 21 |
