INTRAC-305 INSTALLATION
© 2011 Advantech Wireless INTRAC-305 MANUAL - Issue 3.2 Page 65
6
6. INSTALLATION
Introduction The INTRAC-305 Intelligent Tracking Antenna Controller is a
direct physical replacement for the Andrew APC300 Antenna
Steptrack Controller. All that is required for the installation is
to remove the APC300 and replace it with the INTRAC-305
and then set-up the INTRAC-305 for the antenna system.
This section provides information on connections and set-up.
The INTRAC-305 requires that certain parameters be set and
certain information be input before it will be able to function
correctly. Some of this information can be obtained from the
APC300 but some will need to be obtained from other
sources. The chart below gives the parameters required by
the INTRAC-305. Four items under “Fitted Options” should
be set to “Not Fitted” (as indicated) as they are not applicable
to APC300 systems. For more information on these settings
see section 3-Operation of this manual.
Electrical supply voltage setting........... ________ volts
Az, El & Pol (if fitted) angles.............Az ____ El ____ Pol ___
Note Once the pointing angles are noted ensure that the antenna is not
moved.
Beacon Level............................................... ________ dB
Beacon Frequency............................... ________ MHz / GHz
Is 18 volts dc LNB supply required on the beacon receiver input N-
type connector. (Only relevant if the SPL IBR-L option is fitted))
Fitted Options Beacon Receiver (IBR-L)................................... Fitted / Not Fitted
Pol Sel A/B......................................................... set to Not Fitted
Polarization........................................................ Fitted / Not Fitted
Mount Type............................................... Az/El or Hrang/Dcl
Resolver Type.........…… x1 or x2 (normally x2 for std Andrew RESK*-300)
Extended Az...................................................... set to Not Fitted
Geared Pol......................................................... set to Not Fitted
Simax Drive....................................................... set to Fitted
Inv Beacon Lock................................................. set to Not Fitted
System Setup Resolver Sense........ Az: true/inv, El: true/inv, Pol :true/inv
Beamwidth......... Azimuth:______ Elevation: _______
Soft Limits ......... Az right: ______ Az left: _________
El up: ________ El down: ________
Pol cw: _______ Pol ccw: ________
Stow Setup - Prelim Position........... Az: ______ El: ______
Final Position....................................Az: ______ El: ______
Stow Use - Prelim Position......... Az Used / Not Used
El Used / Not Used
Final Position................................. Az Used / Not Used
El Used / Not Used
Beacon Threshold........................... _______dB
Station Co-ordinates........ Lat _____ Long _____ Ht in Km _____
Record any stored satellites