Agilent Technologies E6385A manual QyQy0 axy, Gy- y QRac dyx

Reference

Demo (Demonstration) Mode

QyQy0 axy

[sp opxzy”—•l—tzy xzop zqqp•” l rzzo xp—szo qz• mpnzxtyr qlxtwtl• ©t—s —sp z“p•l—tzy zq —sp [p”— Zzq—©l•p2 Ipxz xzop lwwz©” z± —z ”—p“ —s•z±rs —sp xpy±” lyo ”tx±wl—p —p”—tyr ©t—sz±— l WH0 l nzyypn—tzy —z —sp ”©t—ns0 z• p®py l Gl”p Z—l—tzy2

Oy —sp opxz xzop0 —sp ””—px ©tww yz— ”pyo nzxxlyo” —z —sp TZH0 m±— t— ©tww “p•qz•x ®p• x±ns —sp ”lxp l” tq ln—±lww —p”—tyr l Gl”p Z—l—tzy2 bspy xpl”±•pxpy—” l•p ot”“wlpo0 t— “•z®top” ”lx“wp y±xmp•” ty z•op• —z ”sz© sz© —sp “•ty—z±— qz•xl— ©tww l““pl•2

[sp•p l•p —©z xp—szo” qz• py—p•tyr —sp opxz xzop?

•Selecting the procedure named DEMO. and

•Selecting the demo mode using the demo control parameter (see 32. ZZZZ Test Demo Mode [0=normal 1=demo]).

	gy– y QRac dyx
	Select the DEMO procedure as follows:
NOTE	Once the DEMO procedure is loaded,
	. Even if you turn off the Test Set and run the Test Software later, the
	procedure is stored in battery-backed-up memory and will remain ready to run.

gy 85 If the Test Software is running, press the Shift key, then the Pause/Continue key to stop it. gy 95 Press the Menu key. The Test Software will display the SOFTWARE MENU screen.

gy :5 Select the Select Procedure Location: field, then select Card from the drop-down Choices: list.

gy ?5 Select the Select Procedure Filename: field, then select DEMO from the drop-down Choices: list.

gy A5 Press the k1 (Run Test) key to run the Test Software. The Test Software will set the demo control parameter to 1 and operate in demo mode until you load another procedure.

116 Chapter 5

O:\Manuals\E6385A_Amps\Book\Reference.fm