Agilent Technologies E6385A manual MSC BTS Type 1=Series II 2=M 3=MM, MSC Cell Site Number 444 Max

Reference

Parameters

5;2 MSC BTS Type [1=Series II 2=M 3=MM]

Ky—p• —sp ”pwpn—tzy —z ”“pntq—sp —“p zq Gl”p Z—l—tzy —z mp —p”—po2

•If you select 1, indicates to the Test Software that the Base Station to be tested is of the Series II type.

•If you select 2, indicates to the Test Software that the Base Station to be tested is of the Series M type.

•If you select 3, indicates to the Test Software that the Base Station to be tested is of the Series MM type.

18.MSC Cell Site Number [444 Max]

Enter the number of the cell site at which testing is to be performed.

19.MSC ECP Number

Enter the number of the ECP that controls the cell site at which testing is to be performed.

20.MSC Require CP INH at Ant Port [1=Yes]

Enter the selection to determine whether the entire cell site or the specific sector is to be taken out of service.

•If you select 1, all call processing will be inhibited, which takes the entire cell site out of service for testing at the TX antenna ports.

•If you select 0, only the sector that is associated with the specific antenna port at which testing is to be performed will be taken out of service.

NOTE	When testing at the TX Antenna port, always verify that no radios are transmitting on
	the antenna at which testing is to be performed before disconnecting the antenna.
	21. TX Antenna Port Cable Loss
	Enter the value of the cable loss in testing from the TX Antenna port. If you do not
	know this value, use the TX Antenna Port Cable Calibration function of the Test
	Software to measure it. See “TX Antenna Port Cable Calibration” on page 84.
	22. TX Coupling Factor [ANT 0]
	Enter the value of coupling factor for the Base Station TX Test Port for the specified
	antenna.
	23. TX Coupling Factor [ANT 1]
	Enter the value of coupling factor for the Base Station TX Test Port for the specified
	antenna.
	24. TX Coupling Factor [ANT 2]
	Enter the value of coupling factor for the Base Station TX Test Port for the specified
	antenna.
	25. TX Coupling Factor [ANT 3]
	Enter the value of coupling factor for the Base Station TX Test Port for the specified
	antenna.

Reference

Chapter 5 121