Agilent Technologies E6385A manual A48D Qyy- y VS Sy, Zzzz Test Demo Mode 0=normal 1=demo

S A48D Qyy– y VS Sy

Using the Delta Markers function, you can see that a smaller signal is only 120 kHz (four channel spacings) away from the signal you want to measure. In this case, set Parameter 31 - TX Use 230 kHz BW on Data Dev [1=yes] to 0 to reduce the measurement bandwidth, or turn off the other radio.

Reference

Parameters

Reference

By setting the Spectrum Analyzer Span to 0.420 MHz, you can see if any interfering signals exist on either side of the measured signal.

762ZZZZ Test Demo Mode [0=normal 1=demo]

Ky—p• —sp ”pwpn—tzy —z op—p•xtyp ©sp—sp• —sp [p”— Zzq—©l•p ©tww z“p•l—p ty yz•xlw z• opxzy”—•l—tzy xzop2

•If you select 0, the Test Software will run in normal mode, which allows for test measurements.

•If you select 1, the Test Software will run in demonstration mode. This mode appears to run tests, but the tests are simulated because there is no connection to a Base Station. This mode allows you to become familiar with Test Software operation. For details, see “Demo (Demonstration) Mode” on page 116.

Chapter 5 123