Agilent Technologies E6385A manual Puuy hy gy, ?48 Puyy

Performing Tests

Overview

Puuy hy gy

Oq z± oto yz— vyz© —sp Gl”p Z—l—tzy [c Fy—pyyl Wz•— Hlmwp Sz””0 z• —sp Gl”p Z—l—tzy [c [p”— Wz•— Hlmwp Sz””0 z• —sp Gl”p Z—l—tzy [c Hz±“wp• Sz””p” ©spy ± py—p•po —sp ol—l zy —sp Gl”p Z—l—tzy Hzyqtr±•l—tzy Tpy± ”n•ppy0 •±y —sp qzwwz©tyr nlwtm•l—tzy •z±—typ” —z op—p•xtyp —sp”p wz””p”2 Ip—p•xtytyr —sp”p wz””p” t” n•±ntlw —z zm—ltytyr lnn±•l—p —p”— •p”±w—”2

Fnnp”” —sp”p •z±—typ” m wzlotyr lyo •±yytyr —sp [p”— Zzq—©l•p ,”pp “Loading and Running the Test Software” on page 23) and selecting Calibration/Utilities from the Lucent AMPS Tests Main Menu screen. The Test Software will display the Calibration/Utilities Menu screen (see Figure 4-1). After each measurement, the program will enter the value automatically into the Test Software for future testing (without your having to rerun the routines every time that you test). However, if you run a different program after the measurements, you must re-measure (or re-enter) the values the next time that you use the Test Software.

The Calibration procedures are:

•“TX Antenna Port Cable Calibration” on page 84. Run this utility to determine antenna port cable losses at the frequency and power level at which testing will be performed.

•“TX Test Port Cable Calibration” on page 86. Run this utility to determine test port cable losses at the frequency and power level at which testing will be performed.

•“TX Test Port Coupling Measurements” on page 88. Run this utility to determine the exact coupling factor (loss) of the Base Station TX Test Port.

S ?48 Puyy

Performing Tests

Chapter 4 61