Reference
Parameters
6:2 TX Coupling Factor [ANT 4]
Ky—p• —sp ®lw±p zq nz±“wtyr qln—z• qz• —sp Gl”p Z—l—tzy [c [p”— Wz•— qz• —sp ”“pntqtpo ly—pyyl2
6;2 TX Coupling Factor [ANT 5]
Ky—p• —sp ®lw±p zq nz±“wtyr qln—z• qz• —sp Gl”p Z—l—tzy [c [p”— Wz•— qz• —sp ”“pntqtpo ly—pyyl2
6=2 TX Coupling Factor [ANT 6]
Ky—p• —sp ®lw±p zq nz±“wtyr qln—z• qz• —sp Gl”p Z—l—tzy [c [p”— Wz•— qz• —sp ”“pntqtpo ly—pyyl2
6>2 TX Output Power
Ky—p• —sp ®lw±p zq —sp “z©p• wp®pw ,ty ©l——”- —sl— ”sz±wo mp —•ly”xt——tyr l— —sp [c Fy—pyyl “z•—3qzlx u±x“p•2
742 TX Test Port Cable Loss
Ky—p• —sp ®lw±p zq —sp nlmwp wz”” —z mp ±”po ty —p”—tyr q•zx —sp Gl”p Z—l—tzy [c [p”— Wz•—2 Oq yz— vyz© —st” ®lw±p0 ±”p —sp [c Fy—pyyl Wz•— Hlmwp Hlwtm•l—tzy q±yn—tzy zq —sp [p”— Zzq—©l•p —z xpl”±•p t—2 Zpp “TX Test Port Cable Calibration” on page 86.
31.TX Use 230 kHz BW on Data Dev [1=yes]
Enter the selection to determine which of the filters in the Test Set will be used in data deviation measurements in either the Single Radio Test or Full Site Test.
•If you select 1, the 230-kHz filter will be used. This is the default selection.
•If you select 0, the 30-kHz filter will be used.
When using the 230-kHz IF filter, the Base Station must not be transmitting another signal within seven channel spacings (210 kHz) above or below the signal being measured; otherwise the measurement will be in error. In Figure 5-18, the Spectrum Analyzer and delta marker functions are used to illustrate that another signal could
interfere with the measurement. (See thefor information on using the Spectrum Analyzer).
It is preferable to use the 230-kHz filter when possible. However, if it is not possible to turn off a transmitter that is within 210 kHz of the signal to be measured, use the narrow (30-kHz) filter.