Agilent Technologies E6385A manual SySPP0

Performing Tests

Full Site Test (FCC)

SySPP0

[st” —p”— xpl”±•p” ”p®p•lw l”“pn—” zq •lotz “p•qz•xlynp zy zyp z• xz•p •lotz”2 Tpl”±•pxpy—” l•p xlop l— —sp Gl”p Z—l—tzy [c [p”— Wz•—” ty —sp Fy—pyyl Oy—p•qlnp L•lxp0 pwtxtyl—tyr —sp yppo —z —lvp ly py—t•p ly—pyyl qlnp oz©y o±•tyr —p”—tyr2

Gpqz•p —sp —p”— nly •±y0 — —z n•pl—p l q•p–±pyn “wly nzy—ltytyr tyqz•xl—tzy

lmz±— plns •lotz —z mp —p”—po ,”pp “Defining a Frequency Plan” on page 43). Because the Test Software uses the frequency plan to control automatically all of the radios under

test,. If you must test a radio using manual control, use the “Single Radio Test” on page 68.

The measurements made on each radio depends on its type: AMPS or AMPS Setup. The radio type is specified in the frequency plan.

The following measurements are made on all radios:

•TX Frequency Error

•TX Power (at a specific power amplifier step)

•TX Peak (+) Data Deviation

•TX Peak (-) Data Deviation

The following additional measurements are only made on an AMPS radio (not AMPS Setup):

•TX RMS Residual FM

•TX Average Peak Deviation @ −16 dBm

•TX Distortion @ −16 dBm

•TX Peak (+) Deviation @ 0 dBm

•TX Peak (−) Deviation @ 0 dBm

•TX SAT Average Peak Deviation @ 0 Hz

•TX SAT Frequency Error @ 0 Hz

After you have completed testing, if printing an FCC title page is appropriate, see “Printing the FCC Title Page” on page 41.

Performing Tests

Chapter 4 65