Agilent Technologies E6385A manual Gywy, Gy 95 Select the Spectrum Analyzer field

Performing Tests

Spectrum Analyzer

gywy

[st” q±yn—tzy nzyqtr±•p” —sp [p”— Zp— —z ot”“wl ”“pn—•±x ”©pp“”2 O— t” ±”pq±w ty ®p•tqyr —sp “•p”pynp zq l ”trylw z• ”pl•nstyr qz• ty—p•qp•pynp ”z±•np”2

[st” q±yn—tzy xlp “p•qz•xpo ty1”p•®tnp z• z±—1zq1”p•®tnp2 Zpp “Which Base Station Port to Use – TX Test or TX Antenna?” on page 35.

duyu gyw i

The following parameters and specifications are used when running this test. See Chapter 5, “Reference,” on page 95 for descriptions of the parameters and specifications.

duuyy F

•21. TX Antenna Port Cable Loss - when measuring at the antenna foam jumper out of the Antenna Interface Frame.

•When measuring at the Base Station TX Test Port in the Antenna Interface Frame, the TX Coupling factor for the associated antenna must be entered. This is done in parameters 22 through 28.

•30. TX Test Port Cable Loss - when measuring at the Base Station TX Test Port in the Antenna Interface Frame.

gywu /du6Su Y0F

• None used for this test.

gyyw fy hy

Select and run the Spectrum Analyzer test as follows:

gy 85 From the Lucent AMPS Test Main Menu screen, select the Test Selections field. The Test Software will display the Test Selections Menu screen.

gy 95 Select the Spectrum Analyzer field.

gy :5 Enter information about the radio in the Spectrum Analyzer menu.

•Enter the Specified Output Power for the radio to be tested. This is the level that should be present at the output of the Antenna Interface Frame (that would normally connect to the transmit antenna feed line).

•Enter the Cell Site Number for the site.

•Enter the Antenna Number for the antenna connected to the radio.

•Select the Radio Type from the Choices: list: AMPS or AMPS Setup.

74 Chapter 4

O:\Manuals\E6385A_Amps\Book\perftst.fm