Agilent Technologies E6385A manual QyzSyw, Qyzyy- Rx hyz, Qyzy du

Installation

Defining a Frequency Plan

QyzSyw

bspy •±yytyr —sp L±ww Hpww Zt—p [p”— xzop ,”pp “Full Site Test (FCC)” on page 65), you must provide information to the Test Software on the radios in the site being tested. This is done using frequency plans. Frequency plans are defined on a per site basis. There must be one plan for each site to be tested.

Once a plan is defined, you may store it on an SRAM card for later use for modification.

The Test Software supports two methods for entering the information into a frequency plan. The first method uses an editor that is part of the Test Software. In this method, all plan entry is done on the Test Set front panel. The second method uses an external PC with an editing program. In this method, the plan is defined and then downloaded to the Test Set for storage.

Qyzyy– Rx hyz

The process of defining a frequency plan using the editor function of the Test Software requires saving the frequency plan on an SRAM card. Before beginning the plan definition, make certain that an initialized SRAM card is available for file storage.

gy 85 From the Lucent AMPS Test Main Menu, select the Calibration/Utilities field. The Test Software will display the Calibration/Utilities Menu screen.

gy 95 Select the Define Frequency Plan field. The Test Software will display the Define Frequency Plan screen (see Figure 2-13). Note that the display is divided into two parts. The top of the screen is used to perform file functions, and the lower part is used to edit the data. Scroll to the Cell Site field and enter the number of the site for which the plan is to be defined. To do this, either turn the knob to the desired site number and press the knob to select that number, or use the DATA ENTRY keys to enter a site number and either press the Enter key or press the knob to select that number.

S 948: Qyzy du

Installation

Chapter 2 43