Agilent Technologies n3305a, n3304a, n3301a, n3303a, n3306a, n3302a Front Panel Menus At a Glance

					Quick Reference - 1
Front Panel Menus - At a Glance
Address		ADDRESS 5			Sets the GPIB Address
		INTF GPIB			Selects an interface (GPIB or RS232)
	R
		BAUDRATE 300			Selects baud rate (300, 600, 1200, 2400, 4800, 9600) *
	R
		PARITY NONE			Selects message parity (NONE, EVEN, ODD, MARK, SPACE) *
	R
		FLOW NONE			Selects flow control (XON-XOFF, RTS-CTS, DTR-DSR, NONE) *
	R
Recall		*RCL 0			Recalls the instrument state
		*RST			Resets the instrument to its power-on state
	R
Shift	Save	*SAV 0			Saves the present instrument state
Shift	Error	ERROR 0			Displays the number of errors in the SCPI error queue
Shift	Channel	CHANNEL 1			Allows selection of channel to be controlled by the front panel
Shift	Sense	S:PNT			Defines the number of data points in the measurement
	R	S:TIN			Sets the digitizer sample spacing
		S:WIN			Sets the measurement window function (RECT, HANN)
	R
		S:OFF			Defines the data offset in the measurement
	R
		S:C:RNG			Selects the current measurement range
	R
		S:V:RNG			Selects the voltage measurement range
	R
Func		FUNC			Sets the regulation mode (CURR, RES, VOLT)
	R	FNC:MODE			Selects what controls regulating mode (FIX, LIST)
		INP:SHOR			Enable/disables the input short (OFF/ON)
	R
Protect		OC --	--	--	General protection status (overcurrent fault shown)
	R	RRV ---		--	Voltage protection status (remote reverse voltage fault shown)
Meter		XXXX	XXXX		Displays the input voltage and current
	R	XXXX V MAX			Displays the maximum voltage
		XXXX V MIN			Displays the minimum voltage
	R
		XXXX V RMS			Displays the rms voltage
	R
		XXXX A MAX			Displays the maximum current
	R
		XXXX A MIN			Displays the minimum current
	R
		XXXX A RMS			Displays the rms current
	R
		XXXX WATTS			Displays the wattage
	R
		XXXX W MAX			Displays the maximum wattage
	R
		XXXX W MIN			Displays the minimum wattage
	R
Current		CURR			Sets the input current
	R	C:MODE			Sets the current mode (FIXED, LIST)
		C:RANG			Sets the input current range
	R
		C:SLEW			Sets current slew rate
	R
		C:SLW:N			Sets current slew rate for negative transitions
	R
		C:SLW:P			Sets current slew rate for positive transitions
	R
		C:TLEV			Sets the transient input current
	R
		C:TRIG			Sets the triggered input current
	R
Res		RES			Sets the input resistance
	R	R:MODE			Sets the resistance mode (FIXED, LIST)
		R:RANG			Sets the input resistance range
	R
		R:SLEW			Sets resistance slew rate
	R
		R:SLW:N			Sets resistance slew rate for negative transitions
	R
		R:SLW:P			Sets resistance slew rate for positive transitions
	R
		R:TLEV			Sets the transient input resistance
	R
		R:TRIG			Sets the triggered input resistance
	R
					*Only applicable for use with RS-232

15